G2SBA480-E Datasheet, PDF (1/2 Pages) Gulf Semiconductor – SINGLE PHASE GLASS PASSIVATED BRIDGE RECTIFIER Voltage: 800V Current:4.0A

G2SBA480-E
SINGLE PHASE GLASS
PASSIVATED BRIDGE RECTIFIER
Voltage: 800V
Current:4.0A
Features
Plastic package has Underwriters Laboratory Flammability
Classification 94V-0
Glass passivated chip junction
High case dielectric strength
Typical I_R less than 0.1μA
High surge current capability
Ideal for printed circuit board
High temperature soldering guaranteed:
260 ℃ /10 seconds, 0.375”(9.5mm) lead length, 5lbs.(2.3kg)
tension
Mechanical Data
Terminal: Plated leads solderable per MIL-STD 750,
Method 2026
Case: Molded plastic body over passivated junctions
Polarity: Polarity symbol marked on body
Mounting position: any
GBL
Dimensions in millimeters
MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS
(single-phase, half -wave, 60HZ, resistive or inductive load rating at 25°C, unless otherwise stated,
for capacitive load, derate current by 20%)
Symbol
G2SBA480-E
units
Maximum repetitive peak reverse voltage
Maximum RMS voltage
Maximum DC blocking voltage
Maximum average forward
rectified output current
Tc = 50℃(Note1)
Ta = 40℃(Note2)
Peak forward surge current single sine-wave
superimposed on rated load (JEDEC Method)
Maximum instantaneous forward voltage drop per leg at
2.0A
Rating for fusing (t < 8.3ms)
Maximum DC reverse current at
rated DC blocking voltage per leg
Ta = 25°C
Ta = 125°C
Maximum thermal resistance per leg
Vrrm
Vrms
Vdc
If(av)
Ifsm
Vf
I²t
Ir
Rth(ja)
Rth(jc)
800
560
800
4.0
3.0
120
1.0
60
5.0
500
47.0
10.0
V
V
V
A
A
V
A²Sec
µA
℃/W
Operating junction and storage temperature range
Tj, Tstg
-55 to +150
℃
Note:
1. Unit mounted on P.C.B. with 3.0 x 3.0 x 0.11" thick (7.5 x 7.5 x 0.3 cm) Aluminum plate
2. Unit mounted on P.C.B. at 0.375" (9.5mm) lead length and 0.5 x 0.5"(12 x 12mm) copper pads
3. Recommended mounting position is to bolt down on heatsink with silicone thermal compound for maximum heat transfer with #6 screw
Rev.A1
www.gulfsemi.com