GS82583EQ18GK-450 Datasheet, PDF (4/26 Pages) GSI Technology – 8Mb x 36 and 16Mb x 18 organizations available

GS82583EQ18/36GK-500/450/400
Pin Description
Symbol
Description
SA
D[35:0]
Q[35:0]
QVLD[1:0]
CK, CK
KD[1:0],
KD[1:0]
CQ[1:0],
CQ[1:0]
R
W
DLL
RST
ZQ
ZT
MZT[1:0]
PZT[1:0]
Address — Read Address is registered on CK and Write Address is registered on CK.
Write Data — Registered on KD and KD during Write operations.
D[17:0] - x18 and x36.
D[35:18] - x36 only.
Read Data — Aligned with CQ and CQ during Read operations.
Q[17:0] - x18 and x36.
Q[35:18] - x36 only.
Read Data Valid — Driven high one half cycle before valid Read Data.
Primary Input Clocks — Dual single-ended. Used for latching address and control inputs, for internal timing
control, and for output timing control.
Write Data Input Clocks — Dual single-ended. Used for latching write data inputs.
KD0, KD0: latch Write Data (D[17:0] in x36, D[8:0] in x18).
KD1, KD1: latch Write Data (D[35:18] in x36, D[17:9] in x18).
Read Data Output Clocks — Free-running output (echo) clocks, tightly aligned with read data outputs.
Facilitate source-synchronous operation.
Read Enable — Registered on CK. R = 0 initiates a Read operation.
Write Enable — Registered on CK. W = 0 initiates a Write operation.
DLL Enable — Weakly pulled High internally.
DLL = 0: disables internal DLL.
DLL = 1: enables internal DLL.
Reset — Holds the device inactive and resets the device to its initial power-on state when asserted High.
Weakly pulled Low internally.
Driver Impedance Control Resistor Input — Must be connected to V_SS through an external resistor RQ to
program driver impedance.
ODT Impedance Control Resistor Input — Must be connected to V_SS through an external resistor RT to
program ODT impedance.
ODT Mode Select — Set the ODT state globally for all input groups. Must be tied High or Low.
MZT[1:0] = 00: disables ODT on all input groups, regardless of PZT[1:0].
MZT[1:0] = 01: enables strong ODT on select input groups, as specified by PZT[1:0].
MZT[1:0] = 10: enables weak ODT on select input groups, as specified by PZT[1:0].
MZT[1:0] = 11: reserved.
ODT Configuration Select — Set the ODT state for various combinations of input groups when MZT[1:0] =
01 or 10. Must be tied High or Low.
PZT[1:0] = 00: enables ODT on write data only.
PZT[1:0] = 01: enables ODT on write data and input clocks.
PZT[1:0] = 10: enables ODT on write data, address, and control.
PZT[1:0] = 11: enables ODT on write data, input clocks, address, and control.
Type
Input
Input
Output
Output
Input
Input
Output
Input
Input
Input
Input
Input
Input
Input
Input
Rev: 1.06 8/2017
4/26
Specifications cited are subject to change without notice. For latest documentation see http://www.gsitechnology.com.
© 2014, GSI Technology