MBRF1090CT Datasheet, PDF (1/2 Pages) GOOD-ARK Electronics – Dual High-Voltage Schottky Barrier Rectifiers

MBRF1090CT thru MBRF10100CT
Dual High-Voltage Schottky Barrier Rectifiers
Reverse Voltage 90 to 100 Volts Forward Current 10.0 Amperes
Features
‹ Plastic package has Underwriters Laboratory Flammability
Classification 94V-0
‹ Dual rectifier construction, positive center tap
‹ Metal silicon junction, majority carrier conduction
‹ Low power loss, high efficiency
‹ Guardring for overvoltage protection
‹ For use in low voltage, high frequency inverters, free wheeling,
and polarity protection applications
ITO-220AB
Mechanical Data
‹ Case: JEDEC ITO-220AB molded plastic body
‹ Terminals: Plated leads, solderable per MIL-STD-750,
Method 2026
‹ High temperature soldering guaranteed:
250^oC/10 seconds, 0.25" (6.35mm) from case
‹ Polarity: As marked
‹ Mounting Position: Any
‹ Mounting Torque: 10 in-lbs maximum
‹ Weight: 0.08 ounce, 2.24 grams
Maximum Ratings and Electrical Characteristics
( T = 25oC unless otherwise noted )
C
Parameter
Symbol
MBRF1090CT
MBRF10100CT
Maximum repetitive peak reverse voltage
V_RRM
90
100
Working peak reverse voltage
V_RWM
90
100
Maximum DC blocking voltage
V_DC
Maximum average forward
rectified current (See Fig. 1)
Total device
Per leg
I_F(AV)
Peak forward surge current 8.3ms single half sine-wave
superimposed on rated load (JEDEC Method) per leg
I_FSM
90
100
10
5.0
120
Peak repetitive reverse current per leg at t_p = 2.0us, 1KHz
I_RRM
0.5
Voltage rate of change (rated V_R)
Maximum instantaneous forward voltage per leg (Note 4)
dv/dt
10,000
at I_F=5.0A, T_C=25^oC
V_F
at I_F=5.0A, T_C=125^oC
Maximum reverse current per T_J=25^oC
leg at working peak reverse
I
R
voltage (Note 4)
T_J=100^oC
0.85
0.75
100
6.0
Typical thermal resistance per leg
RMS Isolation voltage (MBRF type only) from terminals
to heatsink with t = 1.0 second, RH < 30%
R_θJC
V_ISOL
6.8
4500 (Note 1)
3500 (Note 2)
1500 (Note 3)
Operating junction temperature range
T_J
-55 to +150
Storage temperature range
T_STG
-55 to +150
Notes:
1. Clip mounting (on case), where lead does not overlap heatsink with 0.110" offset
2. Clip mounting (on case), where leads do overlap heatsink
3. Screw mounting with 4-40 screw, where washer diameter is < 4.9 mm (0.19")
4. Pulse test: 300us pulse width, 1% duty cycle
358
Dimensions in inches and (millimeters)
Unit
Volts
Volts
Volts
Amps
Amps
Amps
V/us
Volts
uA
mA
o_C/W
Volts
o_C
o_C