L4TVS5.0A Datasheet, PDF (1/5 Pages) GOOD-ARK Electronics – Surface Mount Transient Voltage Suppressors

L4TVS10A thru L4TVS190A
Surface Mount Transient Voltage Suppressors
Peak Pulse Power 400W Stand-off Voltage 10 to 190V
Features
• Glass passivated junction
• Solder dip 260 °C, 10 s
• Low profile， typical thickness 1.0mm
• Moisture sensitivity: level 1, per J-STD-020
• Excellent clamping capability and Fast response time
• 400W peak pulse power capability with a 10/1000us waveform
• Polarity:Uni-directional
eSGB (SMAF)
Typical Applications
Use in sensitive electronics protection against voltage transients induced by inductive load
switching and lighting on Ics,mosfet,signal lines of sensor units for
consumer,computer,industrial and telecommunication
Maximum Ratings (TA = 25 °C unless otherwise noted)
Parameter
Symbol
Value
Peak power dissipation with a
10/1000us waveform
Peak pulse current with a 10/1000us
waveform
P_PPM1)
I_PPM1)
Minimum 400
See Next Table
Steady state power dissipation
P_M(AV)2)
1
Peak forward surge current,8.3ms
single half sine-wave uni-directional
only
Maximum instantaneous forward
clamping voltage at 25A
Thermal resistance junction to
ambient air
Operating junction and storage
temperature range
I_FSM
V_F
Rthja³⁾
TJ, TSTG
40.0
2.0
75
-65 to +150
Notes:
1) Non-repetitive current,per fig.3 and derated above TA=25℃ per fig.4.
2) Power dissipation mounted on recommended pad layout
3) Thermal resistance from junction to ambient,mounted on PCB with 8.0×8.0mm copper pads
Unit
W
A
W
A
V
℃/W
℃
www.goodark.com
1/5
2014.01-Rev.A