L2TVS10.0A_15 Datasheet, PDF (1/5 Pages) GOOD-ARK Electronics – Surface Mount Transient Voltage Suppressors Peak Pulse Power 200W Stand-off Voltage 10.0 to 190V

L2TVS10.0A thru L2TVS190A
Surface Mount Transient Voltage Suppressors
Peak Pulse Power 200W Stand-off Voltage 10.0 to 190V
Features
• Glass passivated junction
• Moisture sensitivity: level 1, per J-STD-020
• Solder dip 260 °C, 10 s
• Low profile， typical thickness 1.0mm
• Polarity:Uni-directional
• Excellent clamping capability and Fast response time
• 200W peak pulse power capability with a 10/1000us waveform
Typical Applications
eSGB (SMAF)
Use in sensitive electronics protection against voltage transients induced by inductive load
switching and lighting on Ics,MOSFET,signal lines of sensor units for consumer, computer,
industrial and telecommunication
Maximum Ratings (TA = 25 °C unless otherwise noted)
Parameter
Symbol
Value
Peak power dissipation with a
10/1000us waveform
Peak pulse current with a
10/1000us waveform
Steady state power dissipation on
infinite heatsink
Peak forward surge current,8.3ms
single half sine-wave uni-
P_PPM1)
I_PPM1)
P_M(AV)2)
I_FSM
Minimum 200
See Next Table
0.5
30.0
Maximum instantaneous forward
voltage at 25A
Thermal resistance junction to
ambient air
Operating junction and storage
temperature range
V_F
Rthja
TJ, TSTG
3.5
80
-65 to +150
Notes:
1) Non-repetitive current,per fig.3 and derated above TA=25℃ per fig.4.
2) Power dissipation mounted on recommended pad layout
3) Thermal resistance from junction to ambient,mounted on PCB with 8.0×8.0mm copper pads
Unit
W
A
W
A
V
℃/W
℃
www.goodark.com
1/5
2014.04-Rev.A