GBJ8A Datasheet, PDF (1/2 Pages) Pan Jit International Inc. – GLASS PASSIVATED SINGLE-PHASE BRIDGE RECTIFIER(VOLTAGE - 50 to 800 Volts CURRENT - 8.0 Amperes)

GBJ8A thru GBJ8M
Glass Passivated Single-Phase Bridge Rectifiers
Reverse Voltage 50 to 1000 Volts Forward Current 8.0 Amperes
Features
Glass passivated junction
Ideal for printed circuit board
Reliable low cost construction
Plastic material has Underwriters Laboratory Flammability
Classification 94V-0
Surge overload rating to 170 amperes peak
High case dielectric strength of 2500V_RMS
Mechanical Data
Case: GBJ(5S)
Epoxy meets UL-94V-0 Flammability rating
Terminals: Leads solderable per MILSTD-750 Method 2026
High temperature soldering guaranteed:
260^oC/10 seconds, 0.375 (9.5mm) lead length,
5lbs.(2.3kg) tension
Weight: 0.24 ounce, 6.8 grams
Mounting torque: 8.17 in. lbs. max.
Typical Applications
General purpose use in ac-to-dc bridge full wave rectification for
Switching Power Supply, Home Appliances, Office Equipment,
Industrial Automation applications
Package outline dimensions in millimeters
Maximum Ratings and Electrical Characteristics
Rating at 25^oC ambient temperature unless otherwise specified.
Parameter
Symbols GBJ8A GBJ8B GBJ8D GBJ8G GBJ8J GBJ8K GBJ8M Units
Maximum repetitive peak reverse voltage
Maximum RMS voltage
Maximum DC blocking voltage
Maximum average forward rectified output current (See Fig.2)
Peak forward surge current, 8.3ms single half sine-wave
superimposed on rated load (JEDEC Method)
Rating for fusing (t<8.3ms)
V_RRM
V
RMS
V_DC
I_F(AV)
I_FSM
I²t
50
100
200
400
600
800
1000
35
70
140
280
420
560
700
50
100
200
400
600
800
1000
8.0
180
120
Maximum instantaneous forward voltage drop per leg at 4.0A
Maximum DC reverse current
at rated DC blocking voltage per leg
T_A=25^oC
T_A=125^oC
Typical thermal resistance per leg (Note 2)
Dielectric strength (Therminals to case, AC 1 minute)
Operating junction and storage temperature range
V_F
I_R
R_θJC
V_ISO
T_J, T_STG
1.0
5.0
250.0
1.6
2500
-55 to +150
Notes:
1. Unit case mounted on AL plate heatsink
2. Unit mounted on P.C.B.with 4”x0.06" (100x100x1.6mm) copper pads and 0.375" (9.5mm) lead length
3. Recommended mounting position is to bolt down on heatsink with silicone thermal compound for maximum heat transfer with #6 screw
Volts
Volts
Volts
Amps
Amps
A²sec
Volt
uA
o_C/W
Volts
o_C
466