G975 Datasheet, PDF (1/1 Pages) Global Mixed-mode Technology Inc – 2A Low Dropout Regulator with Enable

Global Mixed-mode Technology Inc.
G975
2A Low Dropout Regulator with Enable
Features
„ Adjustable Output Low to 0.8V
„ 260mV Dropout @ 2A, VO 1.2V
„ Over Current and Over Temperature Protection
„ Enable Pin
„ Low Reverse Leakage (Output to Input )
„ Power SOP-8 (FD) Packages with Thermal Pad
„ ±2% Output Voltage
„ VO Power OK Signal
„ 1.05V, 1.2V, 1.8V and 2.5V Options by Setting
ADJ Pin Below 0.2V and Adjustable Externally
Using Resistors
„ VO Pull Low Resistance when Disable
„ VO Soft Start when Enable
Applications
„ Motherboards
„ Peripheral Cards
„ Network Cards
„ Set Top Boxes
„ Notebook Computers
General Description
The G975 is a high performance positive voltage
regulator designed for use in applications requiring
very low Input voltage and very low dropout voltage at
up to 2 amps. It operates with VPP voltage 5V and
output voltage programmable as low as 0.8V. The
G975 features ultra low dropout, ideal for applications
where V_OUT is very close to V_IN. Additionally, the G975
has an enable pin to further reduce power dissipation
while shutdown. The G975 provides excellent regula-
tion over variations in line, load and temperature. The
G975 provides a power OK signal to indicate if the
voltage level of VO reaches 92% of its rating value.
The G975 is available in the power SOP-8 (FD) pack-
age. It is available with 1.05V, 1.2V, 1.8V and 2.5V
internally preset outputs that are also adjustable using
external resistors.
Ordering Information
ORDER
NUMBER
MARKING
G975-105ADJF11U
975-105
G975-120ADJF11U
975-120
G975-180ADJF11U
975-180
G975-250ADJF11U
975-250
Note: F1: SOP-8 (FD)
1: Bonding Code
U : Tape & Reel
e.g. 105 denotes the 1.05V output voltage
TEMP.
RANGE
-40°C~+85°C
-40°C~+85°C
-40°C~+85°C
-40°C~+85°C
PACKAGE
(Pb free)
SOP-8 (FD)
SOP-8 (FD)
SOP-8 (FD)
SOP-8 (FD)
Pin Configuration
Typical Application Circuit
GND 1
G975
8 VEN
ADJ 2
VO 3
Thermal
Pad
7 POK
6 VPP
VO 4
5 VIN
Top View
SOP-8 (FD)
* Thermal Pad can be connected to VIN
** Connect Thermal Pad to ground plate will
have better thermal performance
VPP (5V)
VIN
VO
R1
C_PP
C1 C2
1µF 20µF 20µF
R2
G975
10kΩ
VPP POK
VIN
VEN
VIN
GND
VO
ADJ
0.8 (R1+R2)
VO =
Volts
R2
R2<120kΩ is recommended
Ver: 0.1
Apr 27, 2007
TEL: [phone]
http://www.gmt.com.tw
1