G962_15 Datasheet, PDF (1/1 Pages) Global Mixed-mode Technology Inc – 2A Low Dropout Regulator with Enable

Global Mixed-mode Technology Inc.
G962
2A Low Dropout Regulator with Enable
Features
„ Adjustable Output from 1.2V to 4.8V Using Ex-
ternal Resistors
„ 1.5V, 1.8V and 2.5V options by Setting ADJ Pin
Below 0.2V
„ Fixed 2.5V, 3.3V and 5V Output for TO-252
„ Over current and over temperature protection
„ 500mV dropout @2A
„ Enable pin
„ 10µA quiescent current in shutdown
„ Output recovery mode in OTP
„ Connect ADJ to GND for fixed output mode
„ TO-252 and TO-252-5 Package
Applications
„ Battery powered systems
„ Motherboards
„ Peripheral cards
„ Set Top Boxes
„ Notebook Computers
Ordering Information
ORDER NUMBER
(Pb free/Green)
MARKING
G962-25T45Uf
G962-25
G962-33T45Uf
G962-33
G962-50T45Uf
G962-50
G962-25T45D
G962-25
G962-33T45D
G962-33
G962-50T45D
G962-50
G962-15ADJTJUf
G962-15
G962-18ADJTJUf
G962-18
G962-25ADJTJUf
G962-25
Note: T4: TO-252 TJ:TO-252-5
U & D : Tape & Reel
e.g. 18 denotes the 1.8V output voltage.
Pin Configuration
G962-XXT45
Top View
1
2
3
VIN GND VO
TO-252
General Description
The G962 is a high performance positive voltage
regulator designed for use in applications requiring
very low dropout voltage at up to 2 Amps. Since it has
superior dropout characteristics compared to regular
LDOs, it can be used to supply 2.5V on motherboards
or 1.5V, 1.8V on peripheral cards from the 3.3V supply
thus allowing the elimination of costly heatsinks. An
enable pin further reduces power dissipation while
shut down. The G962 provides excellent regulation
over variations in line, load and temperature.
The G962 is available with 1.5V, 1.8V, 2.5V, 3.3V and
5V internally preset outputs.
TEMP. RANGE
-40°C ~ +85°C
-40°C ~ +85°C
-40°C ~ +85°C
-40°C ~ +85°C
-40°C ~ +85°C
-40°C ~ +85°C
-40°C ~ +85°C
-40°C ~ +85°C
-40°C ~ +85°C
PACKAGE
TO-252
TO-252
TO-252
TO-252
TO-252
TO-252
TO-252-5
TO-252-5
TO-252-5
Typical Application Circuit
VEN
VIN
VO
R3
I_ENH
R1
G962
VEN
VIN
VO
ADJ
GND
C1
4.7µF
C2
10µF
R2
Top View
123 4 5
VEN VIN GND VO ADJ
TO-252-5
Ver: 1.4
Apr 11, 2011
1.2 (R1+R2)
VO =
Volts
R2
R2=12kΩ is recommended
R3 should be connected for current I_ENH
restriction as V_EN > V_IN+0.3V
1
TEL: [phone]
http://www.gmt.com.tw