|
G525_15 Datasheet, PDF (1/1 Pages) Global Mixed-mode Technology Inc – USB High-Side Power Switch Advance Information | |||
|
Global Mixed-mode Technology Inc.
G525
USB High-Side Power Switch Advance Information
Features
 Compliant to USB standard
 Typical 130mΩ, Low MOSFET on resistance, at
5.0V
 500mA minimum continuous load current
 3.0V to 5.5V operating range
 100µA typical on-state supply current
 25µA typical standby supply current
 Output can be forced higher than input when
operating in off state.
 1.2A maximum current limit
 Thermal shutdown protection
 2.4V typical undervoltage lockout (UVLO)
 Open-drain fault flag pin
 Slow turn-on (soft-start) and fast turnoff
 Logic level enable pin, available with active-
high or active-low version
Applications
 High-side power protection switch
 USB power management
 USB host and self-powered hubs
 USB Bus-powered hubs
 Hot plug-in power supplies
 Battery-charger circuits
General Description
The G525 is an integrated high-side power switch op-
timized for self-powered and bus-powered Universal
Serial Bus (USB) applications.
The G525 satisfies the USB standards. The switch's
low on-resistance meets USB voltage drop require-
ments. When the output load exceeds current-limit
threshold, G525 switches into constant mode and limit
the output current to a safe level, which is typically
900mA, well below the UL 25VA safety requirement. An
open-drain flag output is also available to indicate fault
conditions to the local USB controller. Soft start elimi-
nates the momentary voltage drop on the upstream
port that may occur when the switch is enabled in
bus-powered applications.
Besides, a thermal shutdown circuit is included to pre-
vent catastrophic switch failure caused by increasing
power dissipation when continuous heavy loads or
short circuit occurs. A undervoltage lockout (UVLO)
circuit ensures that the device remains off unless there
is a valid input voltage present, and an enable input
that is compatible with both 3.3V and 5V logic.
Ordering Information
ORDER
NUMBER
MARKING
G525-1
G525-1
G525-2
G525-2
G525-1P81U
G525-1
G525-2P81U
G525-2
Note: P1: SOP-8
P8: MSOP-8
1: Bonding Code
U: Tape & Reel
Pin Configuration
ENABLE
Active High
Active Low
Active High
Active Low
TEMP. RANGE
-40°C to +85°C
-40°C to +85°C
-40°C to +85°C
-40°C to +85°C
PACKAGE
(Pb free)
SOP-8
SOP-8
MSOP-8
MSOP-8
Function Block
EN 1
G525
8 OUT
FLG 2
7 IN
GND 3
6 OUT
NC 4
5 NC
SOP-8/MSOP-8
G525
(EN) 1
(FLG) 2
Gate
Control
3 (GND)
6,8 (OUT)
7 (IN)
Ver 2.2
Mar 19, 2008
TEL: 886-3-5788833
http://www.gmt.com.tw
1
|