English
Language : 

G2001 Datasheet, PDF (1/1 Pages) Global Mixed-mode Technology Inc – 6+1CH serial input motor driver IC for DSC
Global Mixed-mode Technology
G2001
6+1CH serial input motor driver IC for DSC
Features
„ Build-in two micro-steps drive mode is possible
from 2-2 phase stepper drive to maximum 256
resolution micro-steps.
„ Built in 2 full-swing/constant voltage/constant
current drivers switched by serial control with
brake function
„ Low on-resistance (1.2Ω, sum of on-resistance of
upside and bottom side)
„ Output current:IOUT<=0.8A(max.) for each channel
„ Build-in thermal shutdown (TSD, 150°C)
„ All power supply systems (VCC, VM12, VM34,
VM5, VM6) can be set up with an independent
power supply
„ Power save mode corresponds by serial control
setup
„ PI (photo interrupter drive) 3 channel built-in.
„ Small 40TQFN (5×5mm) is adopted
„ Build-in POR (power on reset).
Applications
„ Stepping motor driver/ DC motor driver motor
driver for DSC
General Description
G2001 is a 6+1-channel H-Bridge motor drivers IC for the
digital camera and so on. It has two micro-stepping drivers,
two full-swing/constant voltage/constant current drivers.
G2001 can be operated in serial control mode or partial
exterior control mode. When operating in partial exterior
control mode, the mode of each CH is fixed by initial
serial control setting. When operating in serial control
mode, the mode of each driver can be setting by serial
control.
Ordering Information
ORDER
NUMBER
MARKING
G2001RG1U
2001
Note: RG: TQFN5X5-40
1: Bonding Code
U: Tape & Reel
TEMP. PACKAGE
RANGE
(Green)
-20°C to +85°C TQFN5X5-40
Pin Configurations
MOB1 / SDO 1
EXT1 / ST1 2
OUT2B 3
PGND12 4
OUT2A 5
VM12 6
OUT1B 7
PGND12 8
OUT1A 9
GND 10
Thermal
Pad
30 IN3
29 IN4
28 SLD
27 SCLK
26 SDAT
25 VM5
24 OUT5A
23 RNF5
22 OUT5B
21 PI3
CH12:Micro_stepping
CH34:Micro_stepping
CH5: CC/CV/FS
CH6: CC/CV/FS
G2001 TQFN5X5-40
Note: Thermal Pad must connect to the Ground for excellent power dissipation.
Ver: 0.6
Dec 20, 2012
TEL: 886-3-5788833
http://www.gmt.com.tw
1