050_358 Datasheet, PDF (11/16 Pages) Glenair, Inc. – SMPTE 3G-SDI

050-358 Product Brief
PC Board Mount Dual-Transmitter
3G-SDI and HD-SDI, SMF, 3.3V
FIGURE 4 RECOMMENDED HOST BOARD POWER SUPPLY FILTERING CIRCUIT
Fiber Compatibility
The transceiver is capable of transmission up to 10km with 9/125 μm fiber at 1.25Gbps data rate.
Electrostatic Discharge (ESD)
The Transceiver is compatible with ESD levels found in typical manufacturing and operating environments as described
JEDEC EIA JESD22-A114-A, Class 1 (<2000Volts) HBM. Glenair recommends that devices are handled with ESD
precautions to limit exposure to below 500V HBM.
There are two design cases in which immunity to ESD damage is important. The first case is during handling of the
transceiver prior to insertion to the host board. To protect the transceiver, it’s important to use standard industry ESD
handling precautions. These precautions include using grounded wrist straps, work benches, and floor mats in ESD
controlled areas. The ESD sensitivity of the Glenair PCB mount transceiver is compatible with typical industry production
environments.
The second case to consider is static discharges to the exterior of the host equipment after installation, in which case the
transceiver may be subject to system-level ESD requirements.
Application Support
©2015 Glenair, Inc.
GLENAIR, INC.
www.glenair.com
REV: 2
∙ 1211 AIR WAY
US Cage Code 06324
∙ GLENDALE, CA 91201-2497 ∙ TEL: [phone]
PAGE 11 of 16
Printed in USA
∙ FAX: [phone]
E-mail: [e-mail]