600-058-TOOL Datasheet, PDF (1/1 Pages) Glenair, Inc. – HiPer-D Accessories

SERIES 28
HiPer-D Accessories
Band-Master^™ ATS tool and bands for termination of cable braid
600-058 tool, 600-052 and 600-090 band straps
BAND
ASTER™ ATS TOOL AND BANDS
Band-
Master™ ATS 300 series SST/passivate I.A.W. AMS 2700. The Band-Master™ ATS
1
with just one band size. Approved for aerospace and defense, these straps have
successfully passed rigorous shock, vibration and environmental testing.
1 Band installation Tool. Use with .240" (6.10 mm)
wide bands. 6.75 inches (172 mm) length, 1.2
pounds (0.6 Kg.)
2 ^{Standard Band, .240" (6.10 mm) wide. Available}
Figure
Description
Band installation Tool
Part Number
Length
Part Number
Accommodates Diameter
Figure
in. mm Flat
Pre-Coiled
in.
mm
Contact Glenair or visit our website (glenair.com) to view our complete line of Band-Master™ ATS products,
2
including pneumatic tools for high volume production and calibration kits.
LENGTH ± .060 (1.5)
.240 (6.10)
.350 (8.9)
TAIL LENGTH
INDICATOR MARK
BAND ASTER™ SHIELD TERMINATION INSTRUCTIONS
1. Prepare Cable Braid for termination process Shield Termination
Adapter
Retention Lip
Conductors
Braid
(Figure 1).
Clamping Process (Figures 4 thru 8)
2. Push Braid forward over Adapter Retention Lip
to the Adapter Incline Point (or .4" [10.2mm] ^{NOTE: To free Tool Handles, move Holding Clips}
Adapter
1 ^Incline
2
minimum braid length). Milk Braid as required ^{to center of Tool.}
shield termination area (Figure 2).
4. Squeeze Gripper Release Lever and insert
Band into the front end opening of the Tool.
3. Prepare the Band in the following manner:
(NOTE: Circular portion of looped band must
IMPORTANT: Due to Connector/Adapter circum-
always face downward.)
ference, it may be necessary to prepare the Band _{5. Aligning the Band and Tool with the Shield}
E
around the Cable or Retention Area.
A. Roll Band through the Buckle Slot twice.
Termination Area, squeeze Black Pull-Up
Handle repeatedly using short strokes until
(Bands must be double-coiled.)
it locks againstTool Body. (This indicates the
B. Pull on Band until Mark ( ) is within ap-
proximately .250 inch (6.4mm) of Buckle
Band is compressed to the Tool Precalibrated
Tension.)
Slot (Figure 3). The Band may be tightened
NOTE: If alignment of band and shield is un-
further if desired.
satisfactory, tension on band can be relaxed
NOTE: Prepared Band should have ( ) Mark
visible approximately where shown in Figure 3.
by pushing on slotted release lever on top
of tool. Make adjustments as necessary and
again squeeze black pull-up handle.
Buckle
3
5
Tail Length
Indicator Mark
4
6
6. Complete the Clamping Process by squeez-
7. Remove excess band from tool and dispose.
8. Inspect Shield Termination.
7
8
.400 (1.2mm) Min.
Length Braid Over
Termination Area