050_334 Datasheet, PDF (1/2 Pages) Glenair, Inc. – PCB Mount Dual Transceiver Evaluation Board Manual

050-334-EVALBOARD
PCB Mount Dual Transceiver Evaluation Board Manual
Description
The 050-334-EVALBOARD can be used to evaluate 050-333 Board Mount Dual Optical Transceiver
Operating from 100Mbps to 5Gbps data rate. The transceivers can be used for bidirectional fiber optic
link over 4 multimode 50 µm/125 µm or 62.5 µm/125 µm type fiber optic cables.
For purposes of this document, 050-333, will henceforth be referred to as Unit under Test (UUT).
The evaluation board is designed as an interface to allow evaluation of the Optical Transmitters and the
Optical receivers on the board mount dual transceiver module. Devices are powered through the 3.3V
and GND connections.
For each of the transmitters, Fault condition (TXn-Fault) can be monitored via test points and the
Transmitter disable (TXn-Disable) can be controlled via Jumpers.
For each of the receivers, loss of signal (LOSn) state can be monitored via test points.
How to Order
The 050-334 evaluation board is a general test board that can be used to test Glenair Dual-PCB Mount
transceivers. The test board has been designed to support data rates up 12.5Gbps.
GLENAIR, INC. ∙ 1211 AIR WAY ∙ GLENDALE, CA 91201-2497 ∙ TEL: [phone] ∙ FAX: [phone]
www.glenair.com
050-334 Rev 14.0
PAGE 1 of 2
E-mail: [e-mail]