050_329 Datasheet, PDF (1/2 Pages) Glenair, Inc. – Glenair PCB Mount Transceiver Evaluation Board

050-329
Glenair PCB Mount Transceiver Evaluation Board
Description
The 050-329 Evaluation boards can be used to evaluate multiple types of Glenair PCB Mount Optical
transceivers (UUT). The evaluation board has been designed for high data rate operation and
incorporates 4 SMA connectors that interface with high speed 100 ohm differential lines which can
support testing products up to 10Gbps data rates for both multi-mode and single mode applications.
The evaluation board is designed as an interface to allow evaluation of the Optical Transmitter and the
Optical receiver on the board mount transceiver module. Devices are powered through the 3.3V and
GND connections.
For the transmitter, Fault condition (TX-Fault) can be monitored via a test point and the Transmitter
disable (TX-Disable) can be controlled via a Jumper.
For the receiver, loss of signal (LOS) state can be monitored via a test point.
How to Order
The 050-329 evaluation board is a versatile general purpose test board that can be used to test many
models of PCB Mount transceivers. The test board has been designed to have high speed electrical I/O
that is supportive of a few Mbps to 12.5Gbps. The part number development is described below.
GLENAIR, INC. ∙ 1211 AIR WAY ∙ GLENDALE, CA 91201-2497 ∙ TEL: [phone] ∙ FAX: [phone]
www.glenair.com
050-329 Rev 14.1
PAGE 1 of 2
E-mail: [e-mail]