050-330 Datasheet, PDF (1/2 Pages) Glenair, Inc. – Glenair PCB Mount Dual Transmitter

050-330
Glenair PCB Mount Dual Transmitter / Dual Receiver
Evaluation Board
Description
The 050-330 Evaluation boards can be used to evaluate multiple types of Glenair PCB Mount Dual
Optical transmitters / Receivers (UUT). The evaluation board has been designed for high data rate
operation and incorporates 4 SMA connectors that interface with high speed 100 ohm differential lines
which can support testing products up to 10Gbps data rates for both multi-mode and single mode
applications.
The evaluation board is designed as an interface to allow evaluation of the Dual Optical Transmitter and
the Dual Optical receiver on the board mount transceiver module. Devices are powered through the
3.3V and GND connections.
For the transmitter, Fault condition (TX-Fault) can be monitored via a test point and the Transmitter
disable (TX-Disable) can be controlled via a Jumper.
For the receiver, loss of signal (LOS) state can be monitored via a test point.
How to Order
The 050-330 evaluation board is a versatile general purpose test board that can be used to test many
models of PCB Mount Dual Transmitters and Dual Receivers. The test board has been designed to have
high speed electrical I/O that is supportive of a few Mbps to 12.5Gbps. The part number development
is described below.
GLENAIR, INC. ∙ 1211 AIR WAY ∙ GLENDALE, CA 91201-2497 ∙ TEL: [phone] ∙ FAX: [phone]
www.glenair.com
050-330 Rev 14.0
PAGE 1 of 2
E-mail: [e-mail]