GO1515_05 Datasheet, PDF (3/5 Pages) Gennum Corporation – Voltage Controlled Oscillator

DIMENSIONS
NC
GND
V_CTR
GND
65
OUT
55
55
40
GO1515
TOP VIEW
GND
65
40
45
GND
V_CC
All dimensions are in mils
1 mil = 1/1000 inch
Fig. 1 Footprint of the GO1515
NC
GND
OUT
GND
GO1515
TOP VIEW
GND
V_CTR
GND
V_CC
2.0 4.2 6.0
±0.3 ±0.3 MAX
1.6±0.5
4.7±0.3
6.3±0.3
7.8 MAX
2.0 MAX
All dimensions in millimetres.
SOLDERING RECOMMENDATIONS
Reflow Conditions
The device will meet the data sheet specifications after
completing the reflow process according to the profile
shown in Figure 3 or Figure 4. Do not reflow the device
more than twice.
Soldering Flux
Do not use cleaning type flux. Washing the devices after
using cleaning type flux may damage inner parts and affect
performance.
Endurance To Warp
When the device is soldered on a printed circuit board
(dimension: 100mm x 100mm; thickness: 1.6mm) and the
PCB is warped as shown in Figure 2, the device will not be
cracked or damaged.
PCB
VCO
MAX 2mm
Fig. 2 PCB Warp
3 of 5
522 - 40 - 04