GS9090A_10 Datasheet, PDF (1/73 Pages) Gennum Corporation – GenLINX III 270Mb/s Deserializer

GS9090A GenLINX® III 270Mb/s Deserializer
Key Features
• SMPTE 259M-C compatible descrambling and NRZI to
NRZ decoding (with bypass)
• DVB-ASI 8b/10b decoding
• Integrated line-based FIFO for data alignment/delay,
clock phase interchange, DVB-ASI data packet
extraction and clock rate interchange, and ancillary
data packet extraction
• Integrated VCO and reclocker
• Single serial digital input buffer with wide input
sensitivity and common mode point
• User selectable additional processing features
including:
Š TRS, ANC data checksum, and EDH CRC error
detection and correction
Š programmable ANC data detection
Š illegal code remapping
• Internal flywheel for noise immune H, V, F extraction
• Automatic standards detection and indication
• Enhanced Gennum Serial Peripheral Interface (GSPI)
• JTAG test interface
• Polarity insensitive for DVB-ASI and SMPTE signals
• +1.8V core power supply with optional +1.8V or +3.3V
I/O power supply
• Small footprint (8mm x 8mm)
• Low power operation (typically 145mW)
• Pb-free and RoHS compliant
Applications
• SMPTE 259M-C Serial Digital Interfaces
• DVB-ASI Serial Digital Interfaces
Description
The GS9090A is a 270Mb/s reclocking deserializer with an
internal FIFO. When used in conjunction with one of
Gennum’s SDI Cable Equalizers, a receive solution for
SD-SDI and DVB-ASI applications can be realized.
In addition to reclocking and deserializing the input data
stream, the GS9090A performs NRZI-to-NRZ decoding,
descrambling as per SMPTE 259M-C, and word
alignment when operating in SMPTE mode. When
operating in DVB-ASI mode, the device will word align the
data to K28.5 sync characters and 8b/10b decode the
received stream.
The integrated reclocker features a very wide Input
Jitter Tolerance, and is fully compatible with both SMPTE
and DVB-ASI input streams.
The GS9090A includes a range of data processing
functions such as error detection and correction,
automatic standards detection, and EDH support. The
device can also detect and extract SMPTE 352M
payload identifier packets and independently identify the
received video standard. This information is read from
internal registers via the host interface port.
TRS errors, EDH CRC errors, and ancillary data checksum
errors can all be detected and corrected. A single
DATA_ERROR pin is provided which is an inverted logical
'OR'ing of all detectable errors. Individual error status is
stored in internal ‘ERROR_STATUS’ registers.
The GS9090A also incorporates a video line-based FIFO.
This FIFO may be used in four user-selectable modes to
carry out tasks such as data alignment / delay, clock phase
interchange, MPEG packet extraction and clock rate
interchange, and ancillary data packet extraction.
Parallel data outputs are provided in 10-bit multiplexed
format, with the associated parallel clock output signal
operating at 27MHz.
The GS9090A is Pb-free, and the encapsulation
compound does not contain halogenated flame
retardant (RoHS compliant).
GS9090A GenLINX® III 270Mb/s Deserializer
Data Sheet
34714 - 7
May 2010
www.gennum.com
1 of 73