UG30APT Datasheet, PDF (1/2 Pages) General Semiconductor – ULTRAFAST EFFICIENT PLASTIC RECTIFIER

UG30APT THRU UG30DPT
ULTRAFAST EFFICIENT PLASTIC RECTIFIER
Reverse Voltage - 50 to 200 Volts Forward Current - 30.0 Amperes
TO-247AD
0.245 (6.2)
0.225 (5.7)
0.645 (16.4)
0.625 (15.9)
0.840 (21.3)
0.820 (20.8)
0.323 (8.2)
0.313 (7.9)
0.170
(4.3)
0.142 (3.6)
0.138 (3.5)
0.078 REF
(1.98)
10^o
1
2
3
0.160 (4.1)
0.140 (3.5)
0.795 (20.2)
0.775 (19.6)
0.086 (2.18)
0.076 (1.93)
0.127 (3.22)
0.117 (2.97)
1^o REF.
BOTH SIDES
0.203 (5.16)
0.193 (4.90)
30^o
10^o TYP.
BOTH SIDES
0.118 (3.0)
0.108 (2.7)
0.225 (5.7)
0.205 (5.2)
0.048 (1.22)
0.044 (1.12)
PIN 1
PIN 3
PIN 2
CASE
0.030 (0.76)
0.020 (0.51)
Dimensions in inches and (millimeters)
FEATURES
♦ Plastic package has Underwriters Laboratory
Flammability Classification 94V-0
♦ Ideally suited for use in very high frequency switching
power supplies, inverters and as a free wheeling diodes
♦ Ultrafast, 15 nanosecond typical recovery time
♦ Low leakage current
♦ Glass passivated chip junctions
♦ Soft recovery characteristics
♦ Excellent high temperature switching
♦ High temperature soldering guaranteed:
250°C, 0.16” (4.06mm) from case for 10 seconds
MECHANICAL DATA
Case: JEDEC TO-247AD molded plastic body over
passivated chips
Terminals: Plated leads solderable per MIL-STD-750,
Method 2026
Polarity: As marked
Mounting Position: Any
Weight: 2.2 ounces, 6.3 grams
MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS
Ratings at 25°C ambient temperature unless otherwise specified.
Maximum repetitive peak reverse voltage
Maximum RMS voltage
Maximum DC blocking voltage
Maximum average forward rectified current at TC=120°C
Peak forward surge current
8.3 ms single half sine-wave superimposed
on rated load (JEDEC Method) at TC=120°C
Maximum instantaneous forward voltage
per leg at 15A
30A
10A TJ=100°C
Maximum DC reverse current at
rated DC blocking voltage per leg
TA =25°C
TA =100°C
Maximum reverse recovery time (NOTE 1)
Maximum reverse recovery time
(NOTE 2)
TJ= 25°C
TJ=100°C
Maximum recovered stored charge
(NOTE 2)
TJ=25°C
TJ=100°C
Typical junction capacitance (NOTE 3)
Typical thermal resistance (NOTE 4)
Operating and storage temperature range
SYMBOLS
VRRM
VRMS
VDC
I(AV)
UG30APT
50
35
50
UG30BPT UG30CPT
100
150
70
105
100
150
30.0
UG30DPT
200
140
200
UNITS
Volts
Volts
Volts
Amps
IFSM
300.0
Amps
VF
IR
trr
trr
Qrr
CJ
RΘJC
TJ, TSTG
1.0
1.15
0.85
5.0
800.0
20.0
35.0
50.0
22.0
50.0
70.0
2.0
-65 to +150
Volts
µA
ns
ns
nC
pF
°C/W
°C
NOTES:
(1) Reverse recovery test conditions: IF=0.5A, IR =1.0A, Irr=0.25A
(2) trr and Qrr measured at: IF=15A VR=30V, di/dt=50 A/µs, IRR=10% IRM for measurement of trr
(3) Measured at 1.0 MHZ and applied reverse voltage of 4.0 Volts
(4) Thermal resistance from junction to case per leg mounted on heatsink
4/98