GBPC6005 Datasheet, PDF (1/2 Pages) Shanghai Lunsure Electronic Tech – SINGLE PHASE GLASS PASSIVATED BRIDGE RECTIFIER

GBPC6005 THRU GBPC610
GLASS PASSIVATED SINGLE-PHASE BRIDGE RECTIFIER
Reverse Voltage - 50 to 1000 Volts Forward Current - 6.0 Amperes
Case Style GBPC
HOLE FOR
#6 SCREW
0.158 (4.01)
0.142 (3.61)
DIA.
0.630 (16.00)
0.590 (14.98)
0.630 (16.00)
0.590 (14.98)
0.445 (11.30)
0.405 (10.29)
AC
0.445 (11.30)
0.405 (10.29)
0.128 (3.25)
0.048 (1.22)
AC
0.094 (2.4) x 45 degrees
0.040 (1.02) TYP.
FEATURES
♦ Plastic package has carries Underwriters Laboratory
Flammability Classification 94V-0
♦ This series is UL listed under recognized under Component
Index, file number E54214
♦ Glass passivated chip junctions
♦ High case dielectric strength of 1500 VRMS
♦ Typical IR less than 0.5µA
♦ High forward surge current capability
♦ Ideal for printed circuit boards
♦ High temperature soldering guaranteed:
260°C/10 seconds at 5lbs. (2.3 kg) tension
0.042(1.07) _DIA.
0.038(0.96)
0.200 (5.08)
0.160 (4.06)
0.750
(19.05)
MIN.
Polarity shown on side of case: Positive lead by beveled corner
Dimensions in inches and (millimeters)
MECHANICAL DATA
Case: Molded plastic body over passivated junction
Terminals: Plated leads solderable per MIL-STD-750,
Method 2026
Mounting Position: Any (NOTE 1)
Mounting Torque: 5.0 in. - lb. max.
Weight: 0.1 ounce, 2.8 grams
MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS
Ratings at 25°C ambient temperature unless otherwise specified.
GBPC GBPC
SYMBOLS 6005
601
GBPC GBPC
602
604
GBPC
606
Maximum repetitive peak reverse voltage
VRRM
50
100
200 400 600
Maximum RMS bridge input voltage
VRMS
35
70
140 280 420
Maximum DC blocking voltage
VDC
50 100
200 400 600
Maximum average forward
rectified output current at
TC=50°C (NOTE1, 2)
TA=40°C (NOTE 3)
I(AV)
6.0
3.0
Peak forward surge current single sine-wave
superimposed on rated load (JEDEC Method)
IFSM
175.0
Rating for fusing (t<8.3ms)
I²t
127.0
Maximum instantaneous forward voltage drop
per leg at 3.0 Amperes
VF
1.0
Maximum DC reverse current at rated
DC blocking voltage per leg
TA=25°C
TA=125°C
IR
5.0
500.0
Typical junction capacitance per leg (NOTE 4)
CJ
186.0
Typical thermal resistance per leg (NOTE 3)
(NOTE 2)
RΘJA
RΘJC
22.0
7.3
Operating junction temperature range
TJ
-55 to +150
Storage temperature range
TSTG
-55 to +150
NOTES:
(1) Bolt down on heat-sink with silicone thermal compound between bridge and mounting surface for maximum heat transfer with #6 screw
(2) Unit mounted on 5.5 x 6.0 x 0.11" thick (14 x 15 x 0.3cm) Al. Plate
(3) Unit mounted on P.C.B. at 0.375" (9.5mm) lead length with 0.5 x 0.5" (12 x 12mm) copper pads
(4) Measured at 1 MHz and applied reverse voltage of 4.0 Volts
GBPC
608
800
560
800
90.0
4/98
GBPC
610 UNITS
1000 Volts
700 Volts
1000 Volts
Amps
Amps
A²sec
Volts
µA
pF
°C/W
°C
°C