XP95-M Datasheet, PDF (2/2 Pages) Gamewell-FCI by Honeywell – Multi-Sensor

Operation (Continued)
The XP95-M monitors temperature by using a single ther-
mistor network which provides a voltage output propor-
tional to the external air temperature. The thermistor is
calibrated to return a normal air temperature analog value
at 25º C. Information from each sensing element is pro-
cessed and conditioned by an on-board advanced technol-
ogy ASIC and is digitally transmitted to the FACP as a
single analog value comprised of the combined responses
from both the optical and thermal detection elements. The
XP95-M is an intelligent device. Alarm and trouble condi-
tions are determined by the microprocessor in the head,
which also automatically performs drift compensation.
If the sensor reports a condition that matches its pro-
grammed trouble signature, the FACP will report that the
sensor is in trouble and will follow its programmed
response sequence. Likewise, if the status reported
matches the alarm signature, the Gamewell-FCI FACP will
follow the programmed alarm response for the specific
device in alarm. When a sensor is in alarm, the integral
LED in the sensor’s housing will light steady.
The XP95 Multi-Sensor is designed to be connected to a
two-wire SLC circuit carrying both data and a 17V to 28V
DC supply voltage, and it is insensitive to loop connection
polarity. A remote LED indicator may be connected. The
XP95-M is considered the optimum sensor for most gen-
eral applications since it responds to both smoldering and
flaming fires.
Engineer’s Specifications
The contractor shall furnish and install, where indicated on
the plans, a combination photo/heat multi-sensor detector
(Gamewell-FCI model XP95-M) with one of the several
Addressable Mounting Base Options available. The combi-
nation sensor head and twist lock mounting base shall be
UL Listed and UL Listed as compatible with the Gamewell-
FCI fire alarm control panels. The base shall permit free
interchange of sensor heads without requiring any addi-
tional wiring or additional programming of the head or
base. The smoke sensor shall contain an integral LED that
shall latch in when the unit goes into alarm.
Specifications
Quiescent Current 500 mA average
Alarm LED Current .004A
Remote Alarm
Output:
.004A @ 5 VDC
Temperature Range: -5°F - 140°F
Relative Humidity
(Non-Condensing): ^{0% to 95%}
Ordering Information
Model
Description
XP95-M
Multi-Sensor (Analog Addressable
(55000-886)
XP95-B6EZ 6” (15.24 cm) Ultra Low Profile EZ-Fit Mount-
ing Base with X-Pert Card (45681-250)
XP95-B4
4" (10.16 cm) Mounting Base with X-Pert
Addressing Card (45681-210)
XP95-B6R4 6" (15.24 cm) Relay Base (4 Wire) with
X-Pert Addressing Card
XP95-B6SNDR 6" (15.24 cm) Mounting Base with X-Pert
Addressing Card and Audible Alarm
Sounder
71112
Additional Blank X-Pert Addressing Cards
30203
Remote LED (24V)
GAMEWELL-FCI
12 Clintonville Road, Northford, CT 06472-1610 USA • Tel: [phone] • Fax: [phone]
CS-2052 Rev. a1 page 2 of 2
www.gamewell-fci.com