XP95-B4 Datasheet, PDF (1/2 Pages) Gamewell-FCI by Honeywell – Analog Addressable Sensors

Series 95 Bases
Description
Analog Addressable Sensors
The Gamewell-FCI XP-95 Series bases provide superior
flexibility for the installation of the Gamewell-FCI, XP95
family of addressable detectors. Whether the project
requires a 4.0” (10.16 cm), relay or sounder base, the XP95
family has a base to meet building aesthetics, constraints,
retrofit limitations or functional needs. The device address
is held in the base, ensuring that the device address will
not be changed no matter how often a detector is replaced,
and verifying a consistent match between device type and
device address.
Each XP95 analog addressable head is compatible with a
wide variety of XP-95 bases, ranging from one-piece low-
profile units to four-wire relay and sounder bases that can
be controlled individually or as a group. The XP95 Series of
detector bases has been designed to enable sensors to be
plugged-in with minimum force and to have a “one-way-
only” fit. Relay and sounder bases can be addressed and
controlled individually or by a group in response to the
sensor alarms.
Programming
The only programming required at the Series 95 sensors is
address setting, via the patented XPert addressing card.
The card is inserted into the sensor base. When the sensor
head is inserted into the base, the address is automatically
relayed to the sensor. Changing the sensor does not
require additional programming since the address remains
on the XPert Card located in the base. All other sensor-
specific programming is accomplished at the Fire Alarm
Control Panel (FACP). The XPert addressing card ensures
that only the correct device types can be installed in given
locations after cleaning or other maintenance operations.
Installation
The complete range of Series 95 addressable mounting
bases will accept any of the Series 95 sensors. The bases
have a wide interior diameter for ease of access to wires
and terminals. The design of the base is such that the
Features
Series 95
• Compatible with all of the Gamewell-FCI 600 Series
analog addressable detectors
• Base options include:
– 4.0" (10.16 cm) or 6.0" (15.24 cm) ultra-low-profile
bases feature "one-way" fit with low insertion force
– 6.0" (15.24 cm) relay base (4 wire)
– Audible alarm sounder bases controlled individually
or by group
• Device address is stored in the sensor base
• Address is set by patented XPert addressing card
• Compatible with all Gamewell-FCI XP95 protocol
detection devices
An ISO 9000-2000 Company
SIGNALING
S1195
GAMEWELL-FCI
12 Clintonville Road, Northford, CT 06472-1610 USA • Tel: [phone] • Fax: [phone]
Specifications are for information only, are not intended for installation purposes, and are subject to change without notice. No responsibility is assumed by Gamewell-FCI for their use.
©2007 by Honeywell International Inc. All rights reserved.
www.gamewell-fci.com
CS-2048 Rev. a1 page 1 of 2