MMO-6RF Datasheet, PDF (1/2 Pages) Gamewell-FCI by Honeywell – Multi-mod relay output

Velociti^™ Series
MM0-6RF
Description
The FCI Velociti™ Series, multi-mod six relay output
module (MMO-6RF) provides six (6), Form “C” control
relay outputs on one board. Its compact design affords
ease of installation while using a minimum of wall space.
The Velociti^TM Series use a communication protocol that
substantially increases the speed of communication be-
tween the sensors and certain FCI analog addressable
fire alarm controls. These devices operate in a grouped
fashion. If one of the devices in the group has a status
change, the panel’s microprocessor stops the group poll
and concentrates on the single device. The net effect is
response speed up to five times greater than earlier de-
signs.
The MMO-6RF connects to the signaling line circuit
(SLC) of the FCI analog addressable series fire alarm
control panels. Each relay circuit on the MMO-6RF occu-
pies its own address on the control panel’s SLC and can
be programmed to respond to its own individual control-
by-event sequence of operation. The address of the first
relay is set by a pair of rotary code switches on the
MMO-6RF. Each remaining relay circuit is automatically
assigned to its own subsequent address.
The MMO-6RF module includes an address disable
switch that allows one, two, or three addresses to be
turned off to free these addresses for other purposes.
Each relay has its own status LED that flashes to indi-
cate proper polling and lights steady when the circuit has
been activated.
Two (2), multi-mod series units can be mounted in one
MBB-2 cabinet. Additional mounting options include the
MCH-6 chassis that can accommodate six (6), multi-mod
series modules. The MCH-6 chassis can be installed in
custom cabinets or mounted in the MBB-6 cabinet.
The multi-mod series is ideal for applications where cen-
tralized location of circuits is required. As many as thirty-
six (36), Form “C” relays may be located in a cabinet that
is only 12.63” H x 24” W x 6.5” D in dimension saving
valuable wall space in mechanical rooms and electrical
closets and reducing cost of installation.
Multi-Mod Relay
Output Module
MMO-6RF
Features
• Each module provides six (6), individually addressed,
individually programmable form “C” relays.
• Removable wiring terminal blocks allow ease of
installation and servicing.
• Terminal blocks can accommodate 12 to 18 AWG wire.
• Flexible jumper configuration feature allowing up to
three relay addresses to be disabled.
• A wide range of contact ratings.
• Designed for FCI analog addressable series fire
alarm control panels.
• Individual LED indicators*.
• Suitable for retrofit applications.
• Ideal for applications such as elevator control, AHU
control, door holder release or similar functions
requiring multiple relay outputs.
• Two (2), mounting cabinets available for two (2),
(MBB-2 cabinet) to six (6), (MBB-6 cabinet) units.
Note: Only the red LED is operative in panels that do not oper-
ate in Velociti™ mode.
An ISO 9001-2000 Company
Velociti^™ and E3 Series^™ are trademarks of Fire Control Instruments.
GAMEWELL-FCI
12 Clintonville Road, Northford, CT 06472 - Tel: [phone] - Fax: [phone]
Specifications are for information only, are not intended for installation purposes, and are subject to change without notice. No responsibility is assumed by Gamewell-FCI for their use.
©2006 Gamewell-FCI. All rights reserved.
www.gamewell-fci.com
9020-0632 Rev. B page 1 of 2