M500X Datasheet, PDF (1/1 Pages) Gamewell-FCI by Honeywell – Isolator Module

System Sensor
M500X
Description
The System Sensor M500X Fault Isolator modules enable
part of the communications signaling line circuit to con-
tinue operating when a short circuit occurs. The System
Sensor M500X Isolator Module is an automatic switch that
opens when the line voltage drops below four volts. This
module is rigorously designed and tested for electromag-
netic compatibility and environmental reliability, in many
cases exceeding industry standards.
When installing Isolator Modules, the modules should be
spaced between groups of sensors or modules in a signal-
ing line circuit to protect the remainder of the signaling line
circuit. If a short occurs between any two isolators, then
both isolators immediately switch to an open circuit state
and isolate the devices between them. The remaining
units on the signaling line circuit continue to operate. No
more than 20 devices are recommended for each group.
An LED indicator flashes in the normal condition and
lights during a short circuit condition. When the short cir-
cuit is removed, the module will automatically restore the
entire signaling line circuit.
Specifications
Standby Current:
.00045 amps. max.
Operating Temperature
Range:
32° F to 120° F (0° C to 49° C)
Humidity Range:
10% to 93% non-condensing
Voltage Range:
15 - 32 VDC
Communication Line
Impedance:
40 Ohms
Isolation Current:
5 mA max.
Fault Detection Delay: 250 ms min.
Fault Detection
Threshold:
4 volts
Line Restoration
Threshold:
7 volts
Dimensions:
4.5” H x 4” W .25” D
11.4 H x 10.2 W x .6 D cm)
Mounts to a 4” square by 2.8”D
(10. 2 x 7.1 cm) deep box)
*Normal operating current. During power failure, current
drops to 0.045 amp, since the back light is extinguished.
E3 Series^® and NetSOLO^® are registered trademarks of Honeywell International Inc.
Style 7
Isolator Module
M500X
Features
• Up to 20 addressable devices may be grouped
between isolator modules
• Panel controlled status LED
• Low standby current
• Mounts in standard 4” junction box
• Wiring terminals are easily manageable for
troubleshooting purposes
Ordering Information
Model
M500X
Description
Isolator Module
S1949
GAMEWELL-FCI
12 Clintonville Road, Northford, CT 06472-1610 USA • Tel: [phone] • Fax: [phone]
Specifications are for information only, are not intended for installation purposes, and are subject to change without notice. No responsibility is assumed by Gamewell-FCI for their use.
©2008 Honeywell International Inc. All rights reserved.
www.gamewell-fci.com
9020-0677 Rev. A2 page 1 of 1