INI-7100-UTP Datasheet, PDF (1/2 Pages) Gamewell-FCI by Honeywell – Intelligent Network Interface Module

7100 Series
INI-7100
Description
The INI-7100 Intelligent Network Interface module pro-
vides a system that allows you to create a powerful and
highly reliable peer-to-peer, token ring, regenerative net-
work of up to 64, 7100 series fire alarm control panels. The
network can be configured as Style 4, 6, or 7. Two versions
of the INI-7100 are available.
INI-7100-UTP
The INI-7100-UTP is a cost-effective unit that uses con-
ventional 16 or 18 AWG, twisted, non-shielded copper wire
to connect between two nodes. Distances between nodes
can be up to 3,000 feet (914.4 m). Each INI-7100-UTP
regenerates the signal to extend the network another
3,000 feet (914.4 m). See wiring specifications for details.
INI-7100-FO
The INI-7100-FO provides connections to fiber-optic cable
using type ST connectors as well as retaining the ability to
accommodate conventional copper wire. It can use stan-
dard fiber-optic cable up to 200 microns (multi-mode) but is
optimized for 62.5/125 microns. Signal attenuation can be
up to 8 dB between nodes. Fiber-optic cable provides a
network with the highest degree of reliability and survivabil-
ity, impervious to transients, noise or ground faults. It is
ideal for applications where the network must be run over
long distances or between structures.
Network Features
The INI-7100 is mounted inside the 7100 panel and is con-
nected to the 7100 Basic System Module with the included
ribbon cable. A DIP switch on the INI-7100 module is used
to set the address that the INI-7100 unit will occupy on the
network. The network communication protocol is based
upon token passing technology and operates at 625K
baud.
Each 7100 series fire alarm control panel retains all the
features of a standard 7100 panel, providing two signaling
line circuits supporting up to 396 amps.
Intelligent Network
Interface Module
INI-7100 Series
Features
• Peer-to-peer, token-ring, regenerative network operat-
ing at 625K baud.
• Up to 64, INI-7100 modules in one network.
• Supports Versions using either copper wire (INI-7100-
UTP) or both copper wire and fiber-optic cable
(INI-7100-FO).
• Each INI-7100 regenerates the signal to extend the net-
work up to another 3,000 feet (914.4 m) (wire) or fiber-
optic segment (8 dB loss max.)
• Built-in isolation provides for Style 4 or Style 7 wiring.
• Includes non-polarized network connections.
• Network can be configured into regions for maximum
flexibility.
• Mounts inside the 7100 Series control panel cabinets.
SIGNALING
FM
APPROVED
MEA
Approved
FDNY
7165-1703:0125
C
U
R
L
US LISTED
S1949 3006578 COA # 255-02-E _{7165-1703:0105}
GAMEWELL-FCI
12 Clintonville Road, Northford, CT 06472-1610 USA • Tel: [phone] • Fax: [phone]
Specifications are for information only, are not intended for installation purposes, and are subject to change without notice. No responsibility is assumed by Gamewell-FCI for their use.
©2013 by Honeywell International Inc. All rights reserved.
www.gamewell-fci.com
9020-0530 Rev. J page 1 of 2