IF600-RETROFIT Datasheet, PDF (1/2 Pages) Gamewell-FCI by Honeywell – Gamewell to E3 Series

Gamewell
Retrofit Kits
Description
The Gamewell Retrofit Kits offered by Gamewell-FCI pro-
vide a simple way to convert the following existing
Gamewell legacy Systems to a new E3 Series^® fire alarm
panel.
• IF602 panel
• IF610 panel
• IF632 panel
The Retrofit Kits offer a cost-effective solution to change
the Gamewell legacy panels without replacing the existing
Gamewell backbox. This solution eliminates the expensive
cost of repairing walls, buying new cabinets or replacing
the existing Gamewell backbox.
All retrofit kits provide backplates that mount directly into
the Gamewell backboxes. Each backplate includes mount-
ing patterns to allow an easy installation of the E3 Series
plates and sub-assemblies. The front panel displays can
be retrofitted to the E3 Series LCD-E3/LCD-SLP using a
simple mounting plate. IF600XL retrofit kits include a 3-bay
slot door for addressable switch buttons, LED drivers, and
a paging microphone.
Gamewell RAN annunciator can also be retrofitted to
accommodate an E3 Series supported annunicator by
reusing the existing backbox.
Retrofitting is a cost effective way to upgrade your facilities’
fire alarm control panel without swapping out smoke detec-
tors and notification devices. Changing your legacy
Gamewell System to the Gamewell-FCI, E3 Series System
converts your fire alarm system, so that it is compliant with
the most current UL^® and NFPA codes and standards.
Installation
To retrofit from a Gamewell panel to an E3 Series System,
refer to the following time-saving steps which can save a
lot in setup and labor costs.
1. Remove all field wiring from the legacy Gamewell
control boards that are installed inside the cabinet.
2. Remove the front door or inner doors.
3. Unscrew the Gamewell panel mounting plate from the
backbox.
4. Install the new retrofit mounting plate for E3 Series
sub-assemblies or plates.
5. Install the new E3 Series panels and connect with the
existing wiring.
6. Auto configure the system or custom program the E3
Series.
UE3L^{®Seisrieasr®}egiisstaerreedgistrtaedreedmtararkdeomf UanrkdeorfwHriotenre’sywLealbl oInratetornriaetsioInnacl.Inc.
Gamewell to E3 Series^®
IF600XL
B-Slim
Features
• Listed under UL^® Standard 864, 9th edition.
• Cost effective solution for upgrading an existing system
without buying a complete E3 Series System.
• Upgrades to the state-of-the-art E3 Series fire alarm
control panels.
• Offers a simple plate system for easy installation.
• Allows the existing cabinet to remain mounted on the
wall.
• Reuses the existing System Sensor or Apollo detectors/
modules, and notification devices.
• Remote annunciator retrofit available.
E3 Series Features
For additional information on the E3 Series features, refer
to the E3 Series Data Sheet Part Number: 9020-0637.
SIGNALING
S1869
GAMEWELL-FCI
12 Clintonville Road, Northford, CT 06472-1610 USA • Tel: [phone] • Fax: [phone]
Specifications are for information only, are not intended for installation purposes, and are subject to change without notice. No responsibility is assumed by Gamewell-FCI for their use.
©2014 by Honeywell International Inc. All rights reserved.
www.gamewell-fci.com
9021-60678 Rev. D page 1 of 2