B200SR-LF Datasheet, PDF (1/1 Pages) Gamewell-FCI by Honeywell – Backwards-Compatible Sounder Base

Velociti^® Series
B200SR-LF
Description
•
The Gamewell-FCI, B200SR-LF sounder base sets a new
standard for performance, installation and aesthetics. The
B200SR-LF low frequency sounder base is designed to
comply with the NFPA Standard 72 sleeping space require-
ment to produce a fundamental frequency of 520 Hz +/-
10% with a square wave or its equivalent. Studies show
that a lower frequency, centered around 520 Hz, is the
ideal frequency to awaken sleeping occupants, even those
occupants with mild to severe hearing loss. In addition, it
offers maximum flexibility in installation, configuration and
operation to comply or exceed the UL Standards 268 and
464 requirements.
•
The B200SR-LF sounder base is compatible with the
B501BH Series sounder base installations. By removing
the jumper, the device enables users to select one of two
B501-supported tones (ANSI Temporal 3 or Continuous).
•
Installation
The sounder base offers the following installation features:
• Pre-wired mounting plate that fits various junction box
sizes.
• The housing locks to a mounting plate with two retaining
screws to prevent tamper resistance.
Specifications
Physical Specifications:
Base Diameter:
6.875” (17.46 cm)
Base Height:
Shipping Weight:
2.0” (5.08 cm) less sensor
0.60 lb. (272 gm)
Operating
For applicable sensor Operat-
Temperature Range:
ing Temperature Range, refer
to the Base/Sensor Cross Ref-
erence Chart at the link:
www.systemsensor.com
Operating Humidity
10% to 93% relative humidity
Range:
(non-condensing)
•
Electrical Specifications:
External Supply Voltage: 16 to 33 VDC (VFWR)
External Supply Standby
Current:
1 mA maximum
Alarm Current:
65 mA max. @ 33.0 VDC
90 mA max. @ 24.0 VDC
125 mA max. @ 16.0 VDC
SLC Operating Voltage: 15 to 32 VDC
SLC Standby Current: Refer to applicable sensor
specification
Sound Output:
High Volume:
Greater than 85 dBA minimum
measured in a UL reverberant
room at 10 ft. 24 Volts (in con-
tinuous tone)
E3 Series^® is a registered trademark and the S3 Series™ is a trademark of Honeywell
International Inc.
UL^® is a registered trademark of Underwriters Laboratories Inc.
Backwards-Compatible
Sounder Base
B200SR-LF
Features
•
• Complies with UL^® Standard 464 for 520 Hz. low
frequency.
• Complies with UL Standard 268.
• Supports 520 Hz +/- 10% square wave tone.
• Includes a tone selection via an onboard jumper.
• Compatible with the B501BH-Series sounder base
installations.
• Includes a pre-wire mounting plate that fits various
junction box sizes.
• Offers a mechanical locking feature that prevents the
removal of an attached sensor head.
•
Ordering Information
Part Number Description
B200SR-LF Low Frequency, Backwards-
Compatible Sounder Base
Note: The B200SR-LF sounder base is compatible with
the 7100 Series, E3 Series, and S3 Series fire alarm con-
trol panels.
SIGNALING
S1911
GAMEWELL-FCI
12 Clintonville Road, Northford, CT 06472-1610 USA • Tel: [phone] • Fax: [phone]
Specifications are for information only, are not intended for installation purposes, and are subject to change without notice. No responsibility is assumed by Gamewell-FCI for their use.
©2016 by Honeywell International Inc. All rights reserved.
www.gamewell-fci.com
9021-60843 Rev. C page 1 of 1