ASD-PL2F_13 Datasheet, PDF (1/2 Pages) Gamewell-FCI by Honeywell – Analog, Addressable Photoelectronic Smoke Sensor

Velociti^® Series
ASD-PL2F, ASD-PTL2F
and ASD-PL2FR
Description
The Gamewell-FCI Velociti^® Series, analog address-
able plug-in smoke sensors with integral communica-
tion provide features that surpass conventional
sensors. Sensitivity can be programmed in the con-
trol panel software, and is continuously monitored
and reported to the panel. Point ID capability allows
each sensor’s address to be set, providing exact
locations for selective maintenance when the cham-
ber contamination reaches an unacceptable level.
The ASD-PL2F photoelectric sensor’s unique optical
sensing chamber is engineered to sense smoke pro-
duced by a wide range of combustion sources. Dual
electronic thermistors add 135°F (57°C) fixed-tem-
perature thermal sensing on the ASD-PTL2F model.
The Velociti^® Series use a communication protocol
that substantially increases the speed of communica-
tion between the sensors and certain Gamewell-FCI
analog addressable fire alarm controls. These
devices operate in a grouped fashion. If one of the
devices in the group has a status change, the panel’s
microprocessor stops the group poll and concen-
trates on the single device. The net effect is a
response speed up to five times greater than earlier
designs.
Ordering Information
Part Number Description
ASD-PL2F Analog, addressable photoelectronic
smoke sensor
ASD-PTL2F Analog, addressable photoelectronic smoke
sensor with thermal sensing
ASD-PL2FR Analog, addressable photoelectronic smoke
sensor used with the DNR duct base when
the remote test is required.
Velociti^® is a registered trademark of Honeywell International Inc.
UL^® is a registered trademark of Underwriters Laboratories Inc.
Analog, Addressable Photoelectronic
Smoke Sensor
ASD-PL2F/ASD-PTL2F
ASD-PL2FR
Features
• Sleek, low-profile design.
• Visual rotary, decimal switch addressing (01-159).
• Built-in functional test switch activated by an external
magnet.
• Bicolor LEDs flash green whenever the sensor is
addressed, and light steady red on alarm.*
• Optional relay, isolator, or sounder bases.
• Low standby current.
• Analog addressable communication.
• Stable communication technique with noise immunity.
• Optional remote, single-gang LED Indicator (RA100Z).
• Compatible with Gamewell-FCI analog addressable
panels.
Note: *Only the red LED is operative in panels that do not operate
in Velociti^® mode.
SIGNALING
S1913
FM MEA
Approved
APPROVED
FDNY
3023594 COA #:219-02-E 7272-1703:0121
Vol.VI
GAMEWELL-FCI
12 Clintonville Road, Northford, CT 06472-1653 USA • Tel: [phone] • Fax: [phone]
Specifications are for information only, are not intended for installation purposes, and are subject to change without notice. No responsibility is assumed by Gamewell-FCI for their use.
©2013 by Honeywell International Inc. All rights reserved.
www.gamewell-fci.com
9020-0617 Rev. J page 1 of 2