MB85RS64A Datasheet, PDF (8/20 Pages) Fujitsu Component Limited. – Memory FRAM 64 K (8 K x 8) Bit SPI

MB85RS64A
• RDSR
The RDSR command reads status register data. After op-code of RDSR is input to SI, 8-cycle clock is input
to SCK. The SI value is invalid for this time. SO is output synchronously to a falling edge of SCK. Continuously
reading status register is enabled by keep on sending SCK before rising CS with the RDSR command.
CS
SCK
SI
SO
0 1 2 3 4 5 6 70 1 2 3 4 5 6 7
00000101
High-Z
MSB
Invalid
Data Out
Invalid
LSB
• WRSR
The WRSR command writes data to the nonvolatile memory bit of status register. After performing WRSR
op-code to a SI pin, 8 bits writing data is input. WEL (Write Enable Latch) is not able to be written with WRSR
command. a SI value correspondent to bit 1 is ignored. Bit 0 of the status register is fixed to “0” and cannot
be written. The SI value corresponding to bit 0 is ignored.
CS
SCK
SI
SO
012345670 1 2 3 4 5 6 7
Instruction
Data In
0000000176543210
MSB
LSB
High-Z
8
DS501-00009-0v01-E