N010-0550-T717 Datasheet, PDF (6/7 Pages) Fujitsu Component Limited. – Resistive Touch Panel Specification FID-550 7-Wire Series

FID-550 SERIES
n 9.0 CONNECTION AND MOUNTING
The details below indicate the recommended mounting structure for panel and enclosure. The enclosure sup-
port to fix the touch panel must be over 1.0mm I width and must be outside the view (Transparent area). Also
ensure that the enclosure does not cause miss input by touching the view area.
The following diagram shows that the enclosure edge must be between the View area and the guaranteed ac-
tive area. Ensure space is allocated for the diodes, and we recommend that the material to fix the panel and
enclosure is elastic. Special design would be required to stop water ingress. The corners of the touch panel
are conductive so do not touch any metal parts after mounting.
Location
Detect

1.
Right/ Upper Glass
2.
Right/ Upper Glass
3.
Each side
Glass
4.
Left/ Lower Glass
5.
Each side
Glass
6.
Left/ Lower Glass
7.
All Film
0.7
3.35
Top View (Picture, with conductive
side down)
Stiffener Board
Conductive Face
Laminate Film
FPC-type cable
Contact Section View
Bottom View (Drawing, with conductive side up)
(Mating connector type FCI or equivalent SFW15R-1STAE1-LF: for FPC)
Transparent Area
Anti-input Area
Input Area
Shock absorber to protect
the panel (eg rubber)
0.8 mm min.
Upper Case
Cut-out / avoidance of
550 surface mount diodes
1.0 to 3.0 mm
Input Panel
Wiring Area
View Area
LCD
Circuit Board
Shock absorber
for protection
Connector