|
FR65E Datasheet, PDF (3/87 Pages) Fujitsu Component Limited. – 32-Bit Microcontroller | |||
|
◁ |
MB91307B
(Continued)
UART
⢠Full duplex double buffer
⢠3-channel
⢠Parity/no parity selection
⢠Asynchronous (start-stop synchronized), CLK-synchronized communications selection
⢠Built-in exclusive baud rate timer
⢠External clock can be used as transfer clock
⢠Variety of error detection functions (parity, frame, overrun)
I2C interface
⢠Master/slave sending and receiving
⢠Arbitration function
⢠Clock synchronization function
⢠Slave address/general call address detection function
⢠Transfer direction detection function
⢠Start condition repeat generator and detection function
⢠Bus error detection function
⢠10-bit/7-bit slave address
⢠Operates in standard mode (Max 100 Kbps) or high speed mode (Max 400 Kbps)
Interrupt controller
⢠Total of 9 external interrupts: 1 non-maskable interrupt pin (NMI) and 8 normal interrupt pins INT7-INT0
⢠Interrupt from internal peripheral devices
⢠Programmable priority settings (16 levels) enabled, except for non-maskable interrupt
⢠Can be used for wake-up from stop mode
A/D converter
⢠10-bit resolution, 4-channel
⢠Sequential comparator type, conversion time approx. 5.4 µs
⢠Conversion modes: single conversion mode, continuous conversion mode
⢠Startup source: software / external trigger / timer output signal
Other interval timers
⢠16-bit timer with 3 channels (U-timer)
⢠Watchdog timer
I/O port
⢠Maximum 69 ports
Other features
⢠Built-in oscillator circuit for clock source, PLL multiplier selection enabled
⢠INIT reset pin
⢠Also included: watchdog timer reset, software reset
⢠Power-saving modes: stop mode, sleep mode supported
⢠Gear functions
⢠Built-in time base timer
⢠Packages: LQFP-120 (FPT-120P-M21) : MB91307B
: MB91V307R(Evaluation product)
⢠CMOS technology
: 0.25 µm
⢠Supply voltage : 3.3 V ± 0.3 V (built-in regulator 3.3 V â 2.5 V)
3
|
▷ |