MBM29F400TC Datasheet, PDF (1/47 Pages) SPANSION – FLASH MEMORY CMOS 4M (512K x 8/256K x 16) BIT

FUJITSU SEMICONDUCTOR
DATA SHEET
DS05-20851-4E
FLASH MEMORY
CMOS
4M (512K × 8/256K × 16) BIT
MBM29F400TC-55/-70/-90/MBM29F400BC-55/-70/-90
s FEATURES
• Single 5.0 V read, write, and erase
Minimizes system level power requirements
• Compatible with JEDEC-standard commands
Uses same software commands as E²PROMs
• Compatible with JEDEC-standard world-wide pinouts
48-pin TSOP (Package suffix: PFTN – Normal Bend Type, PFTR – Reversed Bend Type)
44-pin SOP (Package suffix: PF)
• Minimum 100,000 write/erase cycles
• High performance
55 ns maximum access time
• Sector erase architecture
One 16K byte, two 8K bytes, one 32K byte, and seven 64K bytes.
Any combination of sectors can be concurrently erased. Also supports full chip erase.
• Boot Code Sector Architecture
T = Top sector
B = Bottom sector
• Embedded Erase^TM Algorithms
Automatically pre-programs and erases the chip or any sector
• Embedded Program^TM Algorithms
Automatically writes and verifies data at specified address
• Data Polling and Toggle Bit feature for detection of program or erase cycle completion
• Ready/Busy output (RY/BY)
Hardware method for detection of program or erase cycle completion
• Low Vcc write inhibit ≤ 3.2 V
• Erase Suspend/Resume
Suspends the erase operation to allow a read in another sector within the same device
• Hardware RESET pin
Resets internal state machine to the read mode
• Sector protection
Hardware method disables any combination of sectors from write or erase operations
• Temporary sector unprotection
Temporary sector unprotection via the RESET pin.
Embedded Erase^TM and Embedded Program^TM are trademarks of Advanced Micro Devices, Inc.