CS101 Datasheet, PDF (1/8 Pages) Fujitsu Component Limited. – Standard Cell

FUJITSU SEMICONDUCTOR
DATA SHEET
DS06-20210-2E
Semicustom
CMOS
Standard Cell
CS101 Series
■ DESCRIPTION
CS101 series, a 90 nm standard cell product, is a CMOS ASIC that satisfies user’s demands for lower power
consumption and higher speed. The leakage current of the transistors is the minimum level in the industry. Three
types of core transistors with a different threshold voltage can be mixed according to user application.
The design rules match industry standards, and a wide range of IP macros are available for use.
As well as providing a maximum of 100 million gates, approximately twice the level of integration achieved in
previous products, the power consumption per gate is also reduced by about half to 2.7 nW. Also, using the high-
speed library increases the speed by a factor of approximately 1.3, with a gate delay time of 12 ps.
■ FEATURES
• Technology
: 90 nm Si gate CMOS
7- to 10-metal layers.
Low-K (low permittivity) material is used for all dielectric inter-layers.
Three different types of core transistors (low leak, standard, and high speed)
can be used on the same chip.
The design rules comply with industry standard processes.
• Power supply voltage
: +1.2 V ± 0.1 V (standard)
• Operation junction temperature : − 40 °C to + 125 °C (standard)
• Gate delay time
: tpd = 12 ps (1.2 V, Inverter, F/O = 1)
• Gate power consumption
: Pd = 2.7 nW/MHz/BC (1.2 V, 2 NAND, F/O = 1)
• High level of integration
: Up to 91 million gates
• Reduced chip sized realized by I/O with pad.
• Support for a wide range of cell sets (from low power versions to ultra high speed versions).
• Compliance with industry standard design rules enables non-Fujitsu commercial macros to be easily incorpo-
rated.
• Compiled cell (RAM, ROM, others)
• Support for ultra high speed (up to 10 Gbps) interface macros.
• Special interfaces (LVDS, SSTL2, etc.)
• Supports use of industry standard libraries (.LIB).
• Uses industry standard tools and supports the optimum tools for the application.
(Continued)