EDS8-47N Datasheet, PDF (1/4 Pages) Fuji Electric – HAND-HELD COMMUNICATOR < HHC >

HAND-HELD COMMUNICATOR < HHC >
DATA SHEET
FXW
This instrument is a handy type communicator with built-
in battery, being designed to perform facilitated commu-
nication with operater through use of "smart" type FCX
series transmitter.
FEATURES
1. Simple operation
Adoption of large LCD display (16 digits × 4 lines) as
well as menu assisted software design provides easy-to-
use communication interface.
2. Application to every type of device
The communicator can be used with any "smart" type of
FCX transmitter, FCX-A/C transmitter, FCX-AX transmit-
ter and FCX-AII/CII, AIII transmitter.
3. On-line operation
The communicator can be operated without interrupting
4 to 20mA DC signal.
4. Full variety of protective functions
The communicator incorporates transmitter diagnostic
function, data-write protection key, battery voltage drop
alarm function, automatic power standby function, etc.
5. Optional printer
Set data can be printed on an optional printer.
SPECIFICATIONS
Standard specifications
Applicable device:"Smart" type FCX series transmitter
FCX transmitter
FCX-A/C transmitter
FCX-AX transmitter
FCX-AII/CII transmitter
FCX-AIII transmitter
Transmission line requirement:
Line length; max 2km (0.75 to 1.25mm²
cable.For 1km and above, twist pair-
cable is recommended.)
Load resistance;
250 to 578Ω in case of FCX-1 trans-
mitter
250 to 600Ω in case of FCX-A/C,
FCX-AX, FCX-AII/CII transmitter
(including cable resistance at 24V DC
In case of FCX-AIII transmitter;
Refer to “Load limitations“.
Load capacitance; 0.22µF max.
Load inductance; 3.3mH max.
Separation from power line; 15cm or more
(avoid parallel wiring.)
Display unit: LCD, 16 digits × 4 lines
Operating unit: Flat keys (32 keys), power switch, set
value protection key switch
Power source: Built-in nickel-cadmium battery
Battery life:
24 hours (without option under standard
conditions after full charge)
Charger power source:
100, 115, 230V ±10% AC, 50/60Hz (as
specified)
Charging time: 5 hours
Printer (option): Printing of 24 digits of each remote item
Ambient temperature:
-10 to +50°C
Storage temperature:
-20 to +60°C
Ambient humidity:
90% RH or less
Hazardous locations:
Designed to meet international intrinsic
safety standards.Applications have
been submitted for the following.(In
case of without printer only)
Authorities
ATEX
EEx ia IIC T3
EMC Comformity:
EN61326
Functional specifications
Remote function: See the next page.
Power alarm function:
Battery voltage drop is detected and
indicated by lamp flickering on display
unit (Batt ALM).
Set value protective function:
Set value can be changed by using key
switch
Automatic power standby function:
HHC automatically enters into standby
mode when key is not accessed for
more than 10 minutes (data measure-
ment only).
EDS8-47n
Date Apr. 1, 2011