EDS11-93G Datasheet, PDF (1/8 Pages) Fuji Electric – FC SERIES COMPACT CONTROLLER S(PROGRAMMABLE, CONTINUOUS OUTPUT TYPE)

FC SERIES COMPACT CONTROLLER S
(PROGRAMMABLE, CONTINUOUS OUTPUT TYPE)
DATA SHEET
PNA2
The Compact Controller S (programmable type) is a com-
pact single-loop controller using a microprocessor. It ac-
cepts uniform signal, and signals from thermocouple and
RTD (Resistance bulb) as input, and is equipped with abun-
dant control and computation functions to allow composing
a flexible system with a high cost/performance.
FEATURES
1. Abundant control and computation functions
The controller has a variety of control and computation
functions in addition to PID auto tuning, and also has a
transmission function for data exchange with a host sys-
tem.
2. Control and computation programming can be made
at the site
Since the control and computation functions are built into
wafers (functional units), an optimum program or the con-
trol object can be formed just by keying on the front panel.
3. High reliability
LED’s (red and green) are used for the bargraph indicator
and also for the parameter indication (red), and a non vola-
tile memory enables retaining the control and computa-
tion parameters even if power should be interrupted.
FUNCTIONAL DIAGRAM
4. All operation is made from the front panel
Operations such as parameter setting, auto/manual
changeover, hard manual operation etc. are all made from
the front panel.
5. Personal computer interface
Generic interface availability for personal computer (IBM
PC-AT) for supervision, operation, support, maintenance,
etc.
Personal computer
Serial communication interface
Communication Constant Constant
terminals
1
32
Bargraph
indicator
Other controllers
Auxiliary analog input 1
(AI1)
Auxiliary analog input 2
(AI2)
Auxiliary analog input 3
(AI3)
Process variable input
(PV)
External set point input
(CAS)
4 to 20mA,
thermocouple
RTD
conversion
SUB control block
(cascade control, ratio
PV control or schedule
control)
SV Control wafer
MAIn control
block (basic control)
KPV
MV
Control wafer
SV
Auxiliary digital input 1
(DI1)
Auxiliary digital input 2
(DI2)
Auxiliary digital input 3
(DI3)
Pulse input (PI)
Manual mode command (SMV)
Computation wafer
Manual
Fault
up to 24 or 48
wafers usable
Alarm
Auxiliary analog output 1
(AO1)
Compensated PV signal (KPV)
Set point transmit signal (SV)
Manipulated output (current)
(MI+, MI-)
Manipulated output (voltage)
(MV)
Auxiliary digital output 1
(DO1)
Auxiliary digital output 2
(DO2)
High alarm (H)
Low alarm (L)
Manual mode output
(M)
Fault output
(FLT)
FLT Indictor
H Indictor
L Indictor
EDS11-93g
Date Jul. 1, 1994