EDS11-139A Datasheet, PDF (1/6 Pages) Fuji Electric – REPLACE CASE

REPLACE CASE
DATA SHEET
This replacing case is used in a situation where compact
controller E series and F series are replaced with compact
controller M series.
This product is convenient when wiring from the duct is dif-
ficult. It results in substantial labor savings.
SPECIFICATIONS
1.Types of Compact Controller M series models that
may be built-in
Continuous output type controller,
Model : PDA211Aɹ¹² -B
YY
DM
Step output type controller,
Model : PDC211A2-B
Y
Y
M
Continuous output type manual loader,
Model
:
PDB111A2-BA
Y
D
Y
M
Continuous output type setter,
Model : PDF111A2-BRY
Y
M
Continuous output type ratio setter,
Model
:
PDG111Aɹ¹² -BRY
Y
M
Electronic indicator,
Model : PDJ111A2-BYY
Y
M
2. Number of input/output points
The specification such as the influence of the accuracy
and environment corresponds to the specification for
Compact Controller M series.
2-1 Analog inputs
• Points
: MAX. 7 points
• Kind of input : Voltage input
• Input range : 1 to 5V DC
Note: The opening input of an step output type controller is
applicable to voltage input specification only.
2-2 Analog outputs
1) Control output or manipulated output
• Points
: 1 point
• Output signal : 4 to 20mA DC
Note: This function is valid only with a continuous output
type controller or a continuous output type manual
loader.
2) Auxiliary analog output
• Points
: 5 points
• Output signal : 1 to 5V DC
2-3 Digital inputs /outputs
1) Auxiliary digital input signals
• Points
:9 points
PDZE
2) Control output signal (pulse width output “PO”)
• Points
:1 set (2 points)
Note: This function is valid only with an step output type
controller.
Important: Externally cross-connect the control outputs to
prevent the increasing pulse and the decreasing
pulse from being turned on at the same time.
3) Fault output signal (“FLT”)
• Points
:1 point
4) Auxiliary digital output signal
• Points
:10 points (with a continuous output type
instrument or an electronic
type indicator)
8 points (with an step output type
controller)
3. Operation ambient specifications
• Dielectric strength
: 500V AC × 1 minute (Between power
terminals VP, PC and ground terminal)
500V AC × 1 minute (Between signal
terminals and ground terminal)
• Insulation resistance
: 500V DC, 50MΩ or more
• Grounding : D-class grounding
• insuration location
: at room
• Ambient temperature
: 0 to 50˚C (but, 40˚C or less when multi-
row/-tier mounting)
• Temperature change ratio
: 10˚C/H or less
• Ambient humidity
: 5 to 90%RH (not condensed)
• Continuous vibration
: Not specified. Provide a support in the
panel, which should be fixed to the
case for vibration resistance.
• Altiude
: 2000m or lower above the sea level
EDS11-139a
Date Jan. 8, 2008