DS_UMFT311GP Datasheet, PDF (6/14 Pages) Future Technology Devices International Ltd. – DS_UMFT311GP shield board to be used with FT311D Development Module.

DS_UMFT311GP Datasheet
Version 1.0
Document No.: FT_000690 Clearance No.: FTDI# 304
FT311D Module Interface Connector
The LEDs can be controlled from the FT311D Module. The LEDs are OFF by default.
When the GPIO pin connected to the FT311D Module is driven LOW the corresponding
LED is ON.
Vinco Interface Connector
The Vinco Interface Connector is used to connect the FT311 GPIO Board to the Vinco
Development Module. The LEDs can be controlled using this interface. By default the
LEDs are OFF. When the GPIO pin connected to the Vinco Development Module is driven
LOW the corresponding LED is ON.
3.2.1 Components
Component
LED diode
LED diode
2 contact jumper
Linear Voltage Regulator
Capacitor bipolar
Push button momentary switch
Resistor
Capacitor TANTALUM
Polarized Capacitor
Table 3.1 : Board Components
Board Designator
Description
LED0, LED1, LED2, LED3, LED4,
LED5, LED6, LED7
Red LED
LED8
Yellow LED
JP0, JP1, JP2, JP3, JP4, JP5, JP6, JP7 SIP-2
U1
AIC1722-33PUTR, 300mA Low Dropout
Linear Voltage Regulator
C1, C2, C4
0.1uF
PB0, PB1, PB2, PB3, PB4, PB5, PB6,
PB7
EVQPAC04, Push button momentary
switch; 4.3 - 5.0mm height
R0, R1, R2, R3, R4, R5, R6, R7, R8
470R
C5
4.7uF, CAP TANTALUM 4.7UF 6.3V
20% SMD
C3
47uF
3.2.2 Interfaces
Interface
FT311D Module Interface connector
Board Designator
P8
Vinco Development Module Interface
connectors
J1, J2, J3, J4, J5
J6
Power Supply Connector
Table 3.2 : Board Interfaces
CN1
Description
Female Socket 5X2. Used to connect to
the FT311D Module
8 Pin male Header 2.54mm
6 Pin; 0.1" (2.54mm); Single Row; male
header
2.1mm Power Jack
Copyright © 2012 Future Technology Devices International Limited
6