UMFT234XF Datasheet, PDF (5/13 Pages) Future Technology Devices International Ltd. – UMFT234XF Development Module

4 CBUS Signal Options
UMFT234XF Datasheet
Version 1.0
Document Reference No.: FT_000818 Clearance No.: FTDI# 337
CBUS Signal
Option
Available On
CBUS Pin
Description
Tristate
DRIVE_1
DRIVE_0
TXDEN
CBUS0
CBUS0
CBUS0
CBUS0
IO Pad is tri-stated
Output a constant 1
Output a constant 0
Enable transmit data for RS485
PWREN#
CBUS0
Output is low after the device is configured by USB but high during USB
suspended mode. This output is used to control power to external logic.
TXLED#
CBUS0
Transmit data LED drive – open drain pulses low when transmitting data via
UART.
RXLED#
CBUS0
Receive data LED drive – open drain pulses low when receiving data via
UART.
TX&RXLED#
CBUS0
LED drive – open drain pulses low when transmitting or receiving data via
UART.
SLEEP#
CBUS0
Goes low during USB suspend mode. Typically used to power down external
logic to RS232 level converter IC in USB to RS232 converter designs
CLK24MHz
CBUS0
24 MHz Clock output.**
CLK12MHz
CBUS0
12 MHz Clock output.**
CLK6MHz
CBUS0
6 MHz Clock output.**
GPIO
CBUS0
CBUS bit bang mode option. Allows up to 4 of the CBUS pins to be used as
general purpose I/O. A separate application note, AN232R-01, available
from FTDI website (www.ftdichip.com) describes in more detail how to use
CBUS bit bang mode.
BCD_Charger
CBUS0
Battery Charge Detect indicates when the device is connected to a dedicated
battery charger host. Active high output. NOTE: Requires a 10K pull-down
to remove power up toggling.
BCD_Charger#
CBUS0
Active low BCD Charger, driven by an open drain to ground with no internal
pull-up.
BitBang_WR#
CBUS0
Synchronous and asynchronous bit bang mode WR# strobe output.
BitBang_RD#
CBUS0
Synchronous and asynchronous bit bang mode RD# strobe output.
VBUS_Sense
CBUS0
Input to detect when VBUS is present.
Time_Stamp
CBUS0
Toggle signal which changes state each time a USB SOF is received
Keep_Awake#
CBUS0
Active Low input, prevents the chip from going into suspend.
Table 3 CBUS Configuration Control
* PWREN# must be used with a 10kΩ resistor pull up.
**When in USB suspend mode the outputs clocks are also suspended.
5
Copyright © 2013 Future Technology Devices International Limited