FT2232L Datasheet, PDF (23/51 Pages) Future Technology Devices International Ltd. – Dual USB UART / FIFO I.C.

FT2232L Dual USB UART / FIFO I.C.
8.4 Interfacing to 3.3V Logic
Figure 10 - Bus Powered Circuit with 3.3V logic drive and IO supply voltage
3.3V LDO
Regulator
In
Out
Gnd
VCC3V3
3.3V Power to
External Logic
0.1uF
USB "B"
Connector
Ferrite Bead
VCC
1
27R
2
3
4
27R
33nF
10nF
VCC
0.1uF
0.1uF
+
10uF
Decoupling
Capacitors
1.5K
VCC
470R
3 42 14 31
46
0.1uF
VV
CC
CC
6
3v3OUT
8
USB DM
7 _{USB DP}
VV
CC
CC
II
OO
AB
A
V
C
C
VCC3V3
10
SI/WUA
F^FT^T2²2³3²2^LC
VCC3V3
5 _RSTOUT#
4 _RESET#
A
47 _TEST
G
N
D
GG
NN
DD
26
SI/WUB
GG
NN
DD
45 9 18 25 34
Figure 10 shows how to configure the FT2232L to interface with a 3.3V logic devices. In this example, a discrete 3.3V
regulator is used to supply the 3.3V logic from the USB supply. VCCIOA and VCCIOB are connected to the output of
the 3.3V regulator, which in turn will cause the device interface IO pins on both channels to drive out at 3.3V level. It is
also possible to have one IO interface channel driving out at 5V level, and the other at 3.3V level. In this case one of
the VCCIO pins would be connected to 5V, and the other connected to 3.3V.
For USB bus powered circuits some considerations have to be taken into account when selecting the regulator –
a) The regulator must be capable of sustaining its output voltage with an input voltage of 4.35 volts. A Low Drop Out
(LDO) regulator must be selected.
b) The quiescent current of the regulator must be low in order to meet the USB suspend total current requirement of
<= 500μA during USB suspend.
An example of a regulator family that meets these requirements is the MicroChip (Telcom) TC55 Series. These
devices can supply up to 250mA current and have a quiescent current of under 1μA.
DS2232L Version 1.4
© Future Technology Devices International Ltd. 2005 Page 23 of 51