FT232HL-REEL Datasheet, PDF (11/66 Pages) Future Technology Devices International Ltd. – Single Channel Hi-Speed USB to Multipurpose UART/FIFO IC

Document No.: FT_000288
FT232H SINGLE CHANNEL HI-SPEED USB TO MULTIPURPOSE UART/FIFO IC
Datasheet Version 1.82
Clearance No.: FTDI #199
Pin No.
Name
Type
Description
1
OSCI
INPUT Oscillator input.
2
OSCO
OUTPUT Oscillator output.
5
REF
INPUT Current reference – connect via a 12KΩ resistor @ 1% to GND.
6
DM
I/O
USB Data Signal Minus.
7
DP
I/O
USB Data Signal Plus.
42
TEST
INPUT IC test pin – for normal operation must be connected to GND.
34
RESET#
INPUT Reset input (active low).
31
PWRSAV#
INPUT
Table 3.2 Common Function pins
USB Power Save input. This is an EEPROM configurable option which
is set using a ’Suspend on ACBus7 Low’ bit in FT_PROG . This option
is available when the FT232H is on a self powered mode and is used
to prevent forcing current down the USB lines when the host or hub
is powered off.
PWRSAV# = 1 : Normal Operation
PWRSAV# = 0 : FT232H forced into SUSPEND mode.
PWRSAV# can be connected to VBUS of the USB connector (via a
39KΩ resistor). When this input goes high, then it indicates to the
FT232H that it is connected to a host PC. When the host or hub is
powered down then the FT232H is held in SUSPEND mode.
Copyright © Future Technology Devices International Limited
11