FT260S-U Datasheet, PDF (1/61 Pages) Future Technology Devices International Ltd. – HID-class USB to UART/I2C Bridge IC

FT260 HID-CLASS USB TO UART/I2C BRIDGE IC
Version 1.1
Document No.: FT_001272 Clearance No.: FTDI#484
Future Technology Devices
International Ltd.
FT260
(HID-class USB to UART/I²C
Bridge IC)
FT260 is a HID-class USB to I²C/UART interface 
Device Controller with the following advanced
features:

 Single chip USB to UART/I²C bridge with
standard Human Interface Device (HID) class
support

 USB2.0 compliant Full Speed device with entire
USB protocol handled on the chip.

 Support 2 USB HID Interfaces, each
corresponding to the on-chip physical
interfaces, I²C and UART

 Pin configuration of enabling HID interface for ^
variety of application
 HID over I²C specification support

 Configurable I²C Master Interface controller
conforming to I²C v2.1 and v3.0 specification.

 Support 4 speed modes defined in I²C-bus
Specification, standard mode (SM), fast mode
(FM), Fast mode plus (FM+), and High Speed ^
mode (HS)
 Robust FTDI UART controller with hardware and ^
software flow control
 Data transfer rate from 1.2 Kbuad to 12 Mbaud ^
(RS422, RS485, RS232) at TTL levels

 Configurable GPIOs can be easily controlled by _
software applications under HID class via the
USB bus


Fully integrated oscillator PLL with no external
crystal required
On-chip eFUSE for USB Vendor ID (VID),
Product ID (PID), and other vendor specific
parameters.
Unique USB serial number generation engine
and programming path to external EEPROM.
Integrated 5V-3.3V-1.8V level converter for
USB I/O.
+5V USB VBUS detection engine
USB Power Configurations; supports bus-
powered, self-powered and bus-powered with
power switching.
USB2.0 Low operating and suspend current;
24mA (active-typ) and 385µA (suspend-typ).
True 3.3V CMOS drive output and TTL input.
(operates down to 1V8 with external pull-ups)
Multiple I/O operating voltage level +3.3V,
+2.5V, +1.8V
pin output drive strength; 4 mA(min) and 16
mA(max)
Integrated power-on-reset circuit.
USB Battery Charger Detection.
UHCI / OHCI / EHCI / XHCI host controller
compatible.
Extended operating temperature range; -40 to
85⁰C.
Available in compact Pb-free 28 Pin WQFN or
TSSOP packages (RoHS compliant).
Neither the whole nor any part of the information contained in, or the product described in this manual, may be adapted or reproduced
in any material or electronic form without the prior written consent of the copyright holder. This product and its documentation are
supplied on an as-is basis and no warranty as to their suitability for any particular purpose is either made or implied. Future Technology
Devices International Ltd will not accept any claim for damages howsoever arising as a result of use or failure of this product. Your
statutory rights are not affected. This product or any variant of it is not intended for use in any medical appliance, device or system in
which the failure of the product might reasonably be expected to result in personal injury. This document provides preliminary
information that may be subject to change without notice. No freedom to use patents or other intellectual property rights is implied by
the publication of this document. Future Technology Devices International Ltd, Unit 1, 2 Seaward Place, Centurion Business Park, Glasgow
G41 1HH United Kingdom. Scotland Registered Company Number: SC136640
Copyright © Future Technology Devices International Limited
1