FT200XD Datasheet, PDF (1/42 Pages) Future Technology Devices International Ltd. – FT200XD USB I2C SLAVE IC Datasheet Version 1.3

FT200XD USB I2C SLAVE IC Datasheet
Version 1.3
Document No.: FT_000628 Clearance No.: FTDI# 265
Future Technology Devices
International Ltd.
FT200XD
(USB I2C SLAVE IC)
The FT200XD is a USB to I²C interface ^
with the following advanced features:
 Single chip USB to I²C interface.

 Up to 3.4MHz, high speed mode, I²C supported _
 Entire USB protocol handled on the chip. No
USB specific firmware programming required.
 Fully integrated 2048 byte multi-time- ^
programmable (MTP) memory storing device
descriptors and CBUS I/O configuration.

 Fully integrated clock generation with no _
external crystal required plus optional clock
output selection enabling a glue-less interface
to external MCU or FPGA.

 512 byte receive buffer and 512 byte transmit ^
buffer utilising buffer smoothing technology to
allow for high data throughput.


FTDI’s royalty-free Virtual Com Port (VCP) and
Direct (D2XX) drivers eliminate the

requirement for USB driver development in 
most cases.

 Unique USB FTDIChip-ID™ feature.
 Configurable CBUS I/O pin.

 Transmit and receive LED drive signals.
 USB Battery Charger Detection. Allows for USB
peripheral devices to detect the presence of a
higher power source to enable improved
charging.
 Device supplied pre-programmed with unique
USB serial number.
USB Power Configurations; supports bus-
powered, self-powered and bus-powered with
power switching.
Integrated +3.3V level converter for USB I/O.
True 3.3VCMOS drive output and TTL input;
Operates down to 1V8 with external pull-ups.
Tolerant of 5V input.
Configurable I/O pin output drive strength; 4
mA(min) and 16 mA(max).
Integrated power-on-reset circuit.
Fully integrated AVCC supply filtering - no
external filtering required.
+ 5V Single Supply Operation.
Internal 3V3/1V8 LDO regulators
Low operating and USB suspend current; 8mA
(active-typ) and 125uA (suspend-typ).
UHCI/OHCI/EHCI host controller compatible.
USB 2.0 Full Speed compatible.
Extended operating temperature range; -40⁰C
to +85⁰C.
Available in compact Pb-free 10 Pin DFN
package (3mmx3mm) (RoHS compliant).
Neither the whole nor any part of the information contained in, or the product described in this manual, may be adapted or reproduced
in any material or electronic form without the prior written consent of the copyright holder. This product and its documentation are
supplied on an as-is basis and no warranty as to their suitability for any particular purpose is either made or implied. Future Technology
Devices International Ltd will not accept any claim for damages howsoever arising as a result of use or failure of this product. Your
statutory rights are not affected. This product or any variant of it is not intended for use in any medical appliance, device or system in
which the failure of the product might reasonably be expected to result in personal injury. This document provides preliminar y
information that may be subject to change without notice. No freedom to use patents or other intellectual property rights is implied by
the publication of this document. Future Technology Devices International Ltd, Unit 1, 2 Seaward Place, Centurion Business Park, Glasgow
G41 1HH United Kingdom. Scotland Registered Company Number: SC136640
Copyright © 2013 Future Technology Devices International Limited
1