FSP300-70MU Datasheet, PDF (1/1 Pages) FSP TECHNOLOGY INC. – AC -line powered switching power supply

Medical PSU
FSP300-70MU
DE SC RIP TIO N
This is the specification of Model FSP300-70MU;AC -line
powered switching power supply with active PFC (Power
Factor C orrection) circuit, meet EN61000-3-2 and with Full
Range Input features. Designed and manufactured by FSP
GROUP.
The specification below is intended to describe as
detailedly as possible the functions and performance of the
subject power supply. Any comment or additional
requirements to this specification from our customers will
be highly appreciated and treated as a new target for us to
approach.
SAFETY STANDARD APPAOVAL
W ATTAGE
Wa tta g e :
DIMENSION
Dimension:
300W
190.0mm(L) x 100.0mm(W) x
40.5mm(H)
ENVIRONMENTAL SPECIFICATION
T E MP.Ra ng e :
Operating Temperature:0°C to
+50°C
Storage Temperature: -20°C to +
80℃
INPUT SPECIFICATION
Input Range:
Input Frequency:
Input Current:
Leakage Current:
90-264 Vdc
47-63 Hz
5A(rms) for115VAC , 3A(rms)
for230VAC
µA max. @ 264 VAC ,63 Hz
*Output Voltage and C urrent Rating
Ripple-Noise(R-P) mV
Regulation Load %
Output Max.(A)
Output Min.(A)
+3.3V
0mV
±5%
0A
0A
NO TE S
(1) The +12V1 and +12V2 and +5V and +3.3V total output shall not exceed 281W.
(2)The +12V1 and +12V2 total output shall not exceed 20A.
(3)The +3.3V and +5V total output shall not exceed 120 watts.
(4)Total output for this subject power supply is 300 watts.
(5)Ripple and noise measurements shall be made under all specified load conditions through a single pole low pass filter
with 20MHz cutoff frequency. Outputs shall bypassed at the connector with a 0.1uF ceramic disk capacitor and a 10uF
electrolytic capacitor to simulate system loading.
MECHANICAL SPECIFICATION
This content is subject to change, please refer to specification for m ore detail.
FSP reserve the right to change the content without prior notice