FSP250-20FGBBD Datasheet, PDF (1/1 Pages) FSP TECHNOLOGY INC. – For PoE Switch, PoE NVR and networking system.

IPC PSU
FSP250-20FGBBD
DE SC RIP TIO N
FSP250-20FGBBD is an industrial level of switching power
supply. The power supply comes to offer the total power
capacity up to 250 Watts, and uses unique active PFC
(Power Factor C orrection) circuit design with its high-load
electrical components, makes it to be perfectly used in an
industrial environment. In addition, with its full range of
input and output electrical features, the power supply is
ideally the best choice for PoE Switch, PoE NVR,
communication or any other networking applications to
use. The product also complies with the latest safety and
EMC standards, which is perfectly to meet various
regulations worldwide.
SAFETY STANDARD APPAOVAL
AP P L IC ATIO N
For PoE Switch, PoE NVR and networking system.
FEATURES
80 Plus Bronze
Low Ripple & Noise
Output over voltage protection
Short circuit protection on all outputs
Resettable power shut down
INTERNAL 4 cm fan
100% burn-in under high ambient temperature(50℃)
Vacuum-impregnated transformer
MTBF:100K hours at 25℃
100% Hi-pot tested
Line input fuse protection
W ATTAGE
Wa tta g e :
250W
DIMENSION
Dimension:
150mm(L) x 81.5mm(W) x
40.5mm(H)
PRODUCT HIGHLIGHT
Efficiency Level:
80 Plus Bronze
OUTPUT SPECIFICATION
Hold up Time:
Output Rise Time:
Ripple & Noise:
Short Circuit Protection:
115V/60Hz 20mSec.
Minimum@100% Load,
230V/50Hz 20mSec.
Minimum,@100% Load
115V-rms/230V-rms +12V:
20ms Maximum
115V-rms/230V-rms +53V:
20ms Maximum
12V1:140mV p-p
53V:400mV p-p
load < 0.05 Ohm
ENVIRONMENTAL SPECIFICATION
T E MP.Ra ng e :
Storage Temperature: -
20°C to + 80℃
MT BF :
The power supply have a
minimum predicted
MTBF(MIL-HDBK-217) of
100,000 hours of continuous
operation at 25℃,
maximum-output load, and
nominal AC inout voltage.
INPUT SPECIFICATION
Input Range:
90-264 Vac
Input Frequency: 47-63 Hz
Input Current:
115V@ 5.5 Amps-rms maximum
230V@ 3.2 Amps-rms maximum
GENERAL SPECIFICATION
Effciency:
90% 115VAC
Vo lta g e
+12V: ±5%
Re g ula tio n:
*Output Voltage and C urrent Rating
Ripple-Noise(R-P) mV
Regulation Load %
Output Max.(A)
Output Min.(A)
+12V1
140mV
±5%
7A
0A
+53V
400mV
±5%
3.2A
0A
NO TE S
Total output for this subject power supply is 250 watts.
Ripple and noise measurements shall be made under all specified load conditions through a single pole low pass filter
with 20MHz cutoff frequency. Outputs shall bypassed at the connector with a 0.1uF ceramic disk capacitor and a 10uF
electrolytic capacitor to simulate system loading.
This content is subject to change, please refer to specification for m ore detail.
FSP reserve the right to change the content without prior notice