FSP135-KAAM1 Datasheet, PDF (1/1 Pages) FSP TECHNOLOGY INC. – Medical PSU

Medical PSU
FSP135-KAAM1
DE SC RIP TIO N
This series of AC /DC switching power supplies are for 120-
135 watts of continuous output power. They are enclosed
in a 94V-1 rated polyphenylene-oxide case with an
IEC 320/C 14 or IEC 320/C 18 inlet to mate with
interchangeable cord for world-wide use. All models meet
EN55011, EN55022 and FC C class B emission limits, and
are designed for medical and ITE applications, not for life-
supporting equipment.
FEATURES
Low safety ground leakage current
C lass I models are to be certified to medical and ITE
safety standards, C lass I I models to medical standards
only.
Wide input range 90 to 264 VAC
Power factor corrected 200% peak power capability on
models below 26 Vdc output
Optional output connectors
Over voltage protection
Over current protection
C ompliant with C EC and Energy Star Efficiency level V
requirements
* No load power consumption less than 0.5 W
* Average active efficiency greater than 87%
C ompliant with RoHS requirements
W ATTAGE
Wa tta g e :
DIMENSION
Dimension:
135W
146.2mm(L) x 75.2mm(W) x
39.0mm(H)
SAFETY STANDARD APPAOVAL
OUTPUT SPECIFICATION
Ripple & Noise:
Maximum excursion of 4% or
better on all models,
recovering to 1% of final
value within 500 us after a
25% step load change
Over Current
Protected to short circuit
Protection:
conditions
ENVIRONMENTAL SPECIFICATION
T E MP.Ra ng e :
Operating Temperature:0°C to
+60°C
Storage Temperature: -40°C to +
85℃
OUTPUT ELECTRICAL
Single Output:
24-25 V/ 5.63 A
INPUT SPECIFICATION
Input Range:
Input Frequency:
Input Current:
Leakage Current:
90-264 Vdc
47-63 Hz
1.6A(rms) for115VAC ,
0.8A(rms) for230VAC
200 µA max. @ 264 VAC ,63
Hz
NO TE S
1. C lass I models are equipped with IEC 320/C 14 inlet, and class II models with IEC 320/C 18 inlet.
2. For 10 seconds maximum, average power not to exceed maximum power rating.
3. Ripple and noise is maximum peak to peak voltage value measured at output within 20 MHz bandwidth, at rated line
voltage and output load ranges, and with a 10 μF tantalum capacitor in parallel with a 0.1 μF ceramic capacitor across the
output.
MECHANICAL SPECIFICATION
This content is subject to change, please refer to specification for m ore detail.
FSP reserve the right to change the content without prior notice