2435 Datasheet, PDF (1/1 Pages) Frontier Electronics. – Insert Molded Coil

Frontier Electronics Corp.
667 E. COCHRAN STREET, SIMI VALLEY, CA 93065
TEL: [phone]
FAX: [phone]
E-mail: [e-mail]
Web: frontierusa.com
Insert Molded Coil—2435 series
A. Mechanical Drawing:
B. Electrical Specification:
Part No.
2435-01
2435-02
2435-03
2435-04
2435-05
2435-06
2435-07
L Min. (uH)
0.0460
0.0620
0.0820
0.1080
0.1370
0.1760
0.2220
L Nom. (uH)
0.0475
0.0700
0.0980
0.1300
0.1650
0.2050
0.2450
L Max. (uH)
0.0485
0.0780
0.1140
0.1540
0.1930
0.2340
0.2680
Q Min. @ L Nom.
80 @ 50MHz
85 @ 50MHz
108 @ 50MHz
114 @ 50MHz
114 @ 50 MHz
112 @ 50 MHz
108 @ 40 MHz
Color
Brown
Red
Orange
Yellow
Green
Blue
Violet
C. Features:
1. Plastic molded.
2. High reliability.
3. Low cost.
D. Measurement:
1. Q and L measured with ½” long of TCW#16 soldered along the coil leads and with one end flush with the
bottom of the coil then bent ¼” down from stand off at an angle of 90°.
2. L min. measured with core halfway out of the top of the form.
3. Inductance greater than 0.1uH read at recommended Q meter frequency.
4. Inductance below 0.1uH calculated from readings taken at 50MHz.
E. Test equipment:
Q meter (HP 4342A)
IMC 2435 series
Mar. 15, 2002 Page 1 of 1