MCF51AC256_09 Datasheet, PDF (7/46 Pages) Freescale Semiconductor, Inc – ColdFire Microcontroller

MCF51AC256 Family Configurations
— 24 analog inputs with 12 bits resolution
— Output formatted in 12-, 10- or 8-bit right-justified format
— Single or continuous conversion (automatic return to idle after single conversion)
— Operation in low-power modes for lower noise operation
— Asynchronous clock source for lower noise operation
— Automatic compare with interrupt for less-than, or greater-than or equal-to, programmable
value
— On-chip temperature sensor
• Flexible timer/pulse-width modulators (FTM)
— 16-bit Free-running counter or a counter with initial and final value. The counting can be up
and unsigned, up and signed, or up-down and unsigned
— Up to 6 channels, and each channel can be configured for input capture, output compare or
edge-aligned PWM mode, all channels can be configured for center-aligned PWM mode
– Channels can operate as pairs with equal outputs, pairs with complimentary outputs or
independent channels (with independent outputs)
– Each pair of channels can be combined to generate a PWM signal (with independent control
of both edges of PWM signal)
– Deadtime insertion is available for each complementary pair
— The load of the FTM registers which have write buffer can be synchronized; write protection
for critical registers
— Generation of the triggers to ADC (hardware trigger)
— A fault input for global fault control
— Backwards compatible with TPM
• Timer/pulse width modulator (TPM)
— 16-bit free-running or modulo up/down count operation
— Two channels, each channel may be input capture, output compare, or edge-aligned PWM
— One interrupt per channel plus terminal count interrupt
• Cyclic redundancy check (CRC) generator
— High speed hardware CRC generator circuit using 16-bit shift register
— CRC16-CCITT compliancy with x¹⁶ + x¹² + x⁵ + 1 polynomial
— Error detection for all single, double, odd, and most multi-bit errors
— Programmable initial seed value
• Analog comparators (ACMP)
— Full rail to rail supply operation
— Selectable interrupt on rising edge, falling edge, or either rising or falling edges of comparator
output
— Option to compare to fixed internal bandgap reference voltage
— Option to allow comparator output to be visible on a pin, ACMPxO
• Inter-integrated circuit (IIC)
— Compatible with IIC bus standard
MCF51AC256 ColdFire Microcontroller Data Sheet, Rev.4
Freescale Semiconductor
7