MCF5213_07 Datasheet, PDF (54/56 Pages) Freescale Semiconductor, Inc – ColdFire Microcontroller

Revision History
4 Revision History
Table 37. Revision History
Revision
2
3
Description
• Formatting, layout, spelling, and grammar corrections.
• Added revision history.
• Corrected signal names in block diagram to match those in signal description table.
• Added the following footnote to the MCF5211 FlexCAN entry:
“FlexCAN is available on the MCF5211 only in the 64 QFN package.”
• Added an entry for standby voltage (V_STBY) to the “DC electrical specifications” table.
• Deleted the PSTCLK cycle time row in the “Debug AC timing specifications” table.
• Changed the frequency above the “Min” and “Max” column headings in the “Debug AC timing
specifications” table (was 166 MHz, is 66/80 MHz).
• Changed the minimum value for SNR, THD, SFDR, and SINAD in the “ADC parameters” table (was
TBD, is “—”).
• In the “Pin Functions by Primary and Alternate Purpose” table, changed the value in the
“Pull-up/pull-down” column for IRQ2-IRQ6 (was “—”, is “pull-up”).
• Added values for I_OH and I_OL to the “DC electrical specifications” table.
• Added load test condition information to the “General Purpose I/O Timing” section.
• Deleted the “80 MHz (Peak)” column from the “Current Consumption in Low-Power Mode” table.
• In the “Typical Active Current Consumption Specifications” table, changed the typical active (SRAM)
and peak I_DD values for the 1 MHz core & I/O entry (were TBD, are “—”).
• Changed the I_STBY values In the “Typical Active Current Consumption Specifications” table (were 0 or
TBD, are “—”) and added an explanatory footnote referring to the MCF5213 Device Errata.
• Changed the I_DDA values In the “Typical Active Current Consumption Specifications” table (were TBD,
are 16 mA for normal operation and 50 μA for low-power stop).
• Formatting, layout, spelling, and grammar corrections.
• Synchronized the “Pin Functions by Primary and Alternate Purpose” table in this document and the
reference manual.
• Restructured the part number summary table to include full orderable parts, and changed its name (was
“Part Number Summary”, is “Orderable Part Number Summary”).
• Updated the family configurations table to show that FlexCAN is not available on the MCF5212.
• Added specifications for V_LVD and V_LVDHYS to the “DC electrical specifications” table.
MCF5213 ColdFire Microcontroller, Rev. 3
54
Freescale Semiconductor