MC9S08AC60_11 Datasheet, PDF (3/350 Pages) Freescale Semiconductor, Inc – Microcontrollers

MC9S08AC60 Series Features
8-Bit HCS08 Central Processor Unit (CPU)
• 40-MHz HCS08 CPU (central processor unit)
• 20-MHz internal bus frequency
• HC08 instruction set with added BGND instruction
Development Support
• Background debugging system
• Breakpoint capability to allow single breakpoint
setting during in-circuit debugging (plus two more
breakpoints in on-chip debug module)
• On-chip in-circuit emulator (ICE) Debug module
containing two comparators and nine trigger
modes. Eight deep FIFO for storing
change-of-flow addresses and event-only data.
Supports both tag and force breakpoints.
• Support for up to 32 interrupt/reset sources
Memory Options
• Up to 60 KB of on-chip FLASH memory with
security options
• Up to 2 KB of on-chip RAM
Clock Source Options
• Clock source options include crystal, resonator,
external clock, or internally generated clock with
precision NVM trimming using ICG module
System Protection
• Optional watchdog computer operating properly
(COP) reset with option to run from independent
1kHz internal clock source or bus clock
• Low-voltage detection with reset or interrupt
• Illegal opcode detection with reset
• Cyclic Redundancy Check (CRC) Module to
support fast cyclic redundancy checks on
memory.
Power-Saving Modes
• Wait plus two stops
Peripherals
• ADC — Up to 16-channel, 10-bit analog-to-digital
converter with automatic compare function
• SCI — Two serial communications interface
modules with optional 13-bit break. supports LIN
2.0 Protocol and SAE J2602; Master extended
break generation; Slave extended break detection
• SPI — Serial peripheral interface module
• IIC — Inter-integrated circuit bus module to
operate at up to 100 kbps with maximum bus
loading; capable of higher baudrates with reduced
loading. 10-bit address extension option.
• Timers — Up to two 2-channel and one 6-channel
16-bit timer/pulse-width modulator (TPM) module:
Selectable input capture, output compare, and
edge-aligned PWM capability on each channel.
Each timer module may be configured for
buffered, centered PWM (CPWM) on all channels
• KBI — Up to 8-pin keyboard interrupt module
• CRC - Hardware CRC generation using a 16-bit
shift register
Input/Output
• Up to 54 general-purpose input/output (I/O) pins
• Software selectable pullups on ports when used
as inputs
• Software selectable slew rate control on ports
when used as outputs
• Software selectable drive strength on ports when
used as outputs
• Master reset pin and power-on reset (POR)
• Internal pullup on RESET, IRQ, and BKGD/MS
pins to reduce customer system cost
Package Options
• 64-pin quad flat package (QFP)
• 64-pin low-profile quad flat package (LQFP)
• 48-pin quad flat pack no lead package (QFN)
• 44-pin low-profile quad flat package (LQFP)
• 32-pin low-profile quad flat package (LQFP)