English
Language : 

U-MULTILINK-FX Datasheet, PDF (1/4 Pages) Freescale Semiconductor, Inc – Introduction
P&E Microcomputer Systems, Inc.
www.pemicro.com
Technical Summary for
USB Multilink Universal, Rev. B (PART# USB-ML-UNIVERSAL) and
USB Multilink Universal FX, Rev. A (PART# USB-ML-UNIVERSAL-FX)
Support for Freescale Kinetis® · Qorivva® MPC5xxx · ColdFire® V1/ColdFire+ V1 · ColdFire V2-4
PX Series · HCS08 · RS08 · HC(S)12(X) · S12Z · DSC · HC16/683xx (FX only)
Document# PE4576, Version 1.01
1. Introduction
2. Usage
3. Driver Installation
4. Connecting To The Target
5. Troubleshooting - Startup Reset Sequence
6. Firmware Updates/Architecture Selection
7. Interface Libraries
8. Compatible Software
9. Transition To Production Programming
1
Introduction
USB Multilink Universal & USB Multilink Universal FX
The USB Multilink Universal and Universal FX are all-
in one debug interfaces which accelerate the debug and flash programming process, saving valuable development time. Both
Multilinks provide access to debug modes on a wide range of Freescale microcontroller families by communicating between the
target device and a laptop/PC via the target’s standard debug header and the laptop/PC’s USB port.
FX Note: In addition, the USB Multilink Universal FX offers up to 10X faster download speeds and can provide target
power.
Each of the supported families of Freescale microcontrollers are represented by headers located inside the unit. The headers
for Ports A-D & Port H (FX only) are dual-row with a .100” pitch, and the headers for Ports F-G are dual-row with a .050” pitch.
The pin-outs for these connections and the families that they support are shown below. Port E, the 16-pin JTAG/COP connector,
is not currently supported.
Universal/Universal FX Pin-Outs, Ports A-D
©2012 P&E Microcomputer Systems, Inc. Kinetis, Qorivva, and ColdFire are registered trademarks of Freescale Semiconductor, Inc.
The Power Architecture wordmark and related marks are trademarks and service marks licensed by Power.org.