P2010 Datasheet, PDF (1/2 Pages) Freescale Semiconductor, Inc – single- and dual-core communications processors

QorIQ™ Communications Platforms
P2 Series
P2010 and P2020 single- and dual-core communications processors
Freescale QorIQ™ communications platforms
are the next-generation evolution of our
leading PowerQUICC^® communications
processors. Built using high-performance
Power Architecture^® cores, Freescale
QorIQ platforms enable a new era of
networking innovation where the reliability,
security and quality of service for every
connection matters.
QorIQ P2020 and P2010
Communications Processors
The QorIQ P2 platform series, which includes
the P2020 (dual-core processor) and P2010
(single-core processor) communications
processors, delivers high single-threaded
performance per watt for a wide variety of
applications in the networking, telecom,
military and industrial markets. The series
delivers dual- and single-core frequencies
up to 1.2 GHz on a 45 nm technology
low-power platform.
The QorIQ P2020 and P2010 dual- and single-
core products are pin-compatible with the
QorIQ P1 platform products, offering four
interchangeable cost-effective solutions.
Scaling from a single-core processor at 533
MHz (P1011) to a dual-core processor at
1.2 GHz (P2020), the two QorIQ platforms
together deliver an impressive 4.5x aggregate
frequency range within the same pinout.
The devices in these two series are
software-compatible, sharing the e500
Power Architecture core and peripherals,
as well as being fully software compatible
with the existing PowerQUICC processors.
This enables customers to create a
product with multiple performance points
from a single board design. The P2020
and P1020 dual-core processors support
symmetric and asymmetric multi-processing,
enabling customers to scale performance
through either thread-level or application-
level parallelism.
The P2020 and P2010 communications
processors both have an advanced set
of features for ease of use. The optional
integrated security engine supports the
cryptographic algorithms commonly used
in IPsec, SSL, 3GPP and other networking
and wireless security protocols. The 64-bit
memory controller offers future-proofing
against memory technology migration with
support for both DDR2 and DDR3. It also
supports error correction codes, a baseline
requirement for any high-reliability system.
Other memory types such as flash are
supported through the 16-bit local bus,
USB, SD/MMC and SPI.
The P2010 and P2020 processors integrate
a rich set of interfaces, including SerDes,
Gigabit Ethernet, PCI Express^®, RapidIO^®
technology and USB. The three 10/100/1000
Ethernet ports support advanced packet
parsing, flow control and quality of
service features, as well as IEEE^® 1588
time stamping.
QorIQ™ P2020 and 2010 Block Diagram
Security
Acceleration
(optional)
XOR
Power Architecture^®
e500 Core
32 KB
32 KB
L1 I-Cache L1 D-Cache
512 KB
L2 Cache
Not on P2010
Power Architecture
e500 Core
32 KB
32 KB
L1 I-Cache L1 D-Cache
Coherency Module
System Bus
DDR2/DDR3
SDRAM Controller
Interrupt Control,
SD/MMC, SPI,
USB 2.0/ULPI
Enhanced Local Bus
Controller (eLBC)
3x
Gigabit
Ethernet
On-Chip Network
3 x PCI Express^® 2 x Serial RapidIO^® 2 x 4-ch. DMA
Cores
4-lane SerDes